744367
23
Zoom out
Zoom in
Previous page
1/36
Next page
23
Sprog
1.6 Connecting the flue pipe
Lift the upper cast iron top plate off the stove.
Note: the round cast iron cover plate in the top plate must remain mounted if the stove is being
installed with the flue pipe to the rear, but unscrewed from the upper top plate if the flue pipe
is being installed pointing upwards.
Mounting the flue collar pointing upwards
From the factory, the stove is prepared for installation with the included flue collar (1) pointing
upwards with included ball stop and screws. The ball stop, which prevents the chimney sweep
from damaging the stove’s baffle plates while sweeping, is the 178 mm long rod that is provi-
ded.
Mounting the flue collar to the rear
If the stove is being installed with the flue pipe to the rear, the round plate fixed with two
screws on the back of the stove is dismounted. The iron piece on the inside convection back
panel is knocked out with light, firm taps with a hammer next to the small ”bridges” holding
the piece.
The cast iron cover is removed from the back panel by turning it anticlockwise and mounted on
the inside top plate by pressing it down and turning it clockwise. The lid can act as a cleaning
cover, and facilitate access for the annual cleaning of the stove. The flue collar is centred and
screwed onto the back of the stove with the clamps and screws provided. The ball stop is not
used when installing the flue collar to the rear.
The location of the baffles
The baffles (2) and (3), which are made
from vermiculite, are mounted at the fac-
tory.
Make sure that the baffles are correctly
assembled before lighting the stove
(please see the sketch.)
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Morso 8100 series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Morso 8100 series in the language / languages: English, Danish as an attachment in your email.

The manual is 0,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Morso 8100 series

Morso 8100 series Usermanual and installation guide - German - 20 pages

Morso 8100 series Usermanual and installation guide - Dutch, French - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info