744293
26
Zoom out
Zoom in
Previous page
1/32
Next page
26
DK ENG
2.1 Lighting and refuelling intervals
A lot of air is needed when rst lighting the stove. When starting with a totally cold stove,
it may be helpful to leave the door ajar (2-3 cm) during the rst few minutes; the secondary
air intake, - the upper valve should be fully open. You should build and maintain the ash bed
to a thickness of approximately 1 cm.
The lower valve is only used during the start-up phase and only if you experience bad draft
conditions.
1. We recommend using the “top-down” method to light your
wood-burning stove. It is the most environmentally-friendly
method of lighting. Use two relighters and approx. 1.5 kg of dry
kindling sticks to quickly create a glowing layer of wood. Place
the relighters directly under the top layer of kindling sticks.
2. Fully open the top vent so that the secondary air supply
can enter the rebox.
3. After the paper/re lighters have caught re, leave the
re door ajar about 2-3 cm, so that the chimney draws well.
4. After 5-10 minutes the chimney draft should be estab-
lished, at this point close the re door. If all the necessary
conditions are met, a nice layer of embers will start to ac-
cumulate after another 15 - 20 minutes.
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Morso 1010 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Morso 1010 in the language / languages: English, Danish as an attachment in your email.

The manual is 0,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info