55
www.morphyrichards.com
MMaakkiinngg aa ccaappppuucccciinnoo
Prepare your machine as described
in the section ‘Making a coffee’. Use
your glass jug for measuring the
correct amount of water needed.
FFrrootthhiinngg mmiillkk
It is advised to start heating your
milk at the same time as heating
your coffee or several minutes before
making coffee to ensure milk is hot.
1 Fill the stainless steel milk jug
provided with the required amount of
milk. Do not exceed the maximum
level or add less than the minimum
level.
2 Place the jug on the hot plate and
switch on.
BB
NOTE: You can turn on the hot plate
at the same time as the coffee on/off
switch. It will take approximately 5-7
minutes for the milk to heat up to its
optimum frothing temperature.
3 Lift the milk jug up to the milk frother
blade
CC
. Raise the milk jug ensuring
that the cowl is just under the
surface of the milk - this will give the
maximum froth. Maintain the milk jug
in this position between 30-60
seconds.
WARNING: Take care as the milk
will be hot.
4 Place the milk jug back on the hot
plate to reheat the milk and preserve
the quality of the froth.
NOTE: The jug can stay on the hot
plate until the coffee has finished
brewing but be careful not to burn
your milk/froth.
5 Pour the coffee into cups and gently
pour or preferably spoon the milk
onto the coffee, then sprinkle a little
chocolate powder for the perfect
cappuccino.
6 Turn off the milk frother hot plate by
pressing the on/off switch.
WARNING: the stainless steel jug
and the hotplate will remain hot
for sometime after switching off.
CClleeaanniinngg
The milk frother blade can be wiped
clean still attached to the machine or
it can be removed for easy cleaning
by unscrewing the blade and shaft.
Wash carefully in hot soapy water.
For quick cleaning just after use, fill
up the milk jug with hot water and
run the frother for 30-50 seconds;
repeat the process twice.
If the milk has been left for a long
time the cowl and blade can be
removed and soaked in hot soapy
water for 2-5 minutes before rinsing
clean.
1 Remove the cowl directly after use
and rinse in warm cold water.
DD
It is
recommended that you clean the
blade immediately after use, as dried
milk can be difficult to remove.
The frother blade can be wiped clean
still attached to the machine.
2 If further cleaning is required the
propeller and shaft can be removed.
To replace, insert the stem of the
milk frother blade into the mounting
hole on the unit and screw into
place.
EE
NOTE: If the blade is removed,
ensure that it is fully tightened in
place otherwise the frother will not
operate properly.
3 There may be some splash back of
milk on the underside of the frothing
unit. Switch the unit off then simply
wipe this area clean with a damp
cloth.
WARNING: THE FROTHER ONLY
OPERATES CORRECTLY WHEN
THE COWLING IS CORRECTLY
ASSEMBLED.
DO NOT OPERATE THE FROTHER
DRY OR NOT SUBMERSED IN
LIQUID FOR LONG PERIODS OF
TIME
BB
CC
DD
EE
wwwwww..mmoorrpphhyyrriicchhaarrddss..ccoomm
