55
FILLING
AA
1 Make sure that the iron is not
plugged in, then set the steam
dial
⁄⁄
to ‘0’ position before
filling the iron with water.
2 Lift up the filler cap
››
and fill
the water through the filling hole
into the water tank
··
, using the
beaker provided
AA
.
The tank holds 350ml of water.
After filling, replace the filler cap.
In hard water areas, the use of
distilled or demineralised water
is recommended.
WARNING: Never use battery
topping up fluid or water
containing any substances
like starch, or sugar, or
defrosted water from a
refrigerator.
3 Always pour out the remaining
water after use.
WARNING: When filling your
iron with tap water, always
use the beaker provided.
Never fill directly under the
tap.
TEMPERATURE
CONTROL
BB
• Default setting + 3-dot (cotton)
• To increase temperature press
the top button.
• To decrease temperature press
the bottom button.
• The light panel will flash to
indicate that the iron has not yet
reached the correct
temperature.
• Once the correct temperature
has been reached, the light will
stop flashing and there will be
one ‘beep’ to signal that the iron
is now ready for use.
FEATURES OF YOUR
IRON
Dry ironing
You can use your iron as a dry
iron only. Make sure the variable
steam control
⁄⁄
is set to the ‘0’
symbol.
Any temperature setting may be
used depending on the
garment. The spray feature may
be used, provided there is water
in the tank (see ‘Filling’ section).
You do not need to put any
water in the tank when dry
ironing only.
Water Spray
CC
Press the spray button
‹‹
and
aim the spray of water at
stubborn creases. You can do
this whilst dry ironing providing
there is water in the tank. When
using the water spray it may be
necessary to push the button a
few times to get the spray pump
primed.
A
BB
Increase
temperature
Decrease
temperature
CC
‹
