6
Using the Steam Generator
Plug the appliance into a mains outlet. Press the
On/Off power button (22), it will beep and the
low steam level indicator (24a) will flash.
Remove the detachable water tank (11) by pulling
the water tank handle (10), and fill with water
through the filling aperture (1) to the max fill line
.
Replace the water tank.
IMPORTANT: Never fill the dirty water chamber
(2)
.
IMPORTANT: FOR EXTRA PROTECTION
AGAINST LIMESCALE, USE A MIXTURE OF
50% TAP WATER MIXED WITH 50%
DEIONISED, DISTILLED OR DEMINERALISED
WATER (AVAILABLE AT MOST LARGE
SUPERMARKETS).
NEVER USE MORE THAN 50% DEIONISED,
DISTILLED OR DEMINERALISED WATER AND
NEVER USE SCENTED WATER OR IRONING
WATER.
Never use battery topping up fluid or water
containing any substances like starch, sugar,
fragrant additives or defrosted water from a
refrigerator.
NOTE: Please see point 2 of ‘Exclusions’ on page 12.
Re-filling during use
If the water level is too low, the unit will not
produce steam. If this happens, refill the
detachable water tank (11) with water.
Remove any protective cover from the soleplate (5) and the base unit (16).
Unwind and straighten the power cord and steam supply cord.
Locate the steam generator horizontally on the iron rest plate of your ironing board (if large enough) or on a
heat resistant stand at the same height as your ironing board or below it. Always ensure the steam
generator is on a firm surface when ironing.
WARNING: Do not use the product on a surface which could be damaged by heat or steam such as
a worktop or a polished wood surface.
If in doubt, contact Morphy Richards.
Location
Before use
