646330
6
Zoom out
Zoom in
Previous page
1/8
Next page
ALL FROST DAMAGE IS OUTSIDE OF THE WARRANTY.
Boiler Overheat Protection
The boiler controls will shut down the boiler in the event of overheating. Should this occur, a fault code
will be displayed. Refer to fault codes.
Flame Failure
Should this occur a fault code will be displayed. Refer to fault codes.
Loss of system water pressure
The pressure gauge in the diagram below indicates the central heating system pressure. If the pressure
is seen to fall below the original installation pressure of 1.5 bar over a period of time then there could be
a system leak. In this event re-pressurise the boiler using the filling loop supplied. This is a flexible
detachable pipe that connects the cold water supply to the central heating circuit via two taps directly
beneath the boiler. When the pipe is connected open both taps until the pressure on the gauge reaches
1.5 bar, then close both taps and remove the pipe. The source of the leak must be located and resolved
as repeated use of the filling loop will cause damage to the boiler and the system. If unable to do so or
if the pressure continues to drop a qualified and competent Gas Installer should be consulted.
LOW SYSTEM PRESSURE IS INDICATED BY FAULT CODE “F1” - THE BOILER WILL NOT
OPERATE IF THE PRESSURE HAS REDUCED TO LESS THAN 0.3 BAR.
Condensate Drain
The boiler produces a clear liquid called condensate which leaves the boiler via an internal trap and a drain marked
“J” on the boiler controls diagram. This appliance is fitted with a siphonic condensate trap system that
reduces the risk of the condensate freezing. However should the condensate pipe to this appliance
freeze it will need to be defrosted.
If you do not feel competent to carry out the defrosting instructions below please call a qualified and
competent Gas Installer for assistance.
If you do feel competent to carry out the following instructions please do so with care when handling hot
items.
If this appliance develops a blockage in the condensate pipe, the condensate will build up to a point
where it will make a gurgling noise prior to the boiler stopping and an “L2” fault code being displayed.
Defrosting Instructions
To unblock a frozen condensate pipe;
1. Follow the routing of the plastic pipe from its exit point (”J” on the boiler control diagram) through its
route to its termination point. Locate the frozen blockage. It is likely that the pipe is frozen at the most
exposed point external to the caravan holiday home or where there is some obstruction to flow. This
Pressure Gauge
6


Need help? Post your question in this forum.

Forumrules
1

Forum

morco-gb24

Reset search

  • How can you tell what the temperature is on the boiler ? Submitted on 7-2-2022 at 14:04

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Morco GB24 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Morco GB24 in the language / languages: English as an attachment in your email.

The manual is 0,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Morco GB24

Morco GB24 User Manual - English - 36 pages

Morco GB24 User Manual - Dutch - 10 pages

Morco GB24 User Manual - French - 10 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info