646340
4
Zoom out
Zoom in
Previous page
1/20
Next page
4
GAS SAFETY (INSTALLATION AND USE) REGULATIONS 1998 (AS AMENDED)
It is the law that all gas appliances are installed by a registered person, in accordance with the above regu-
lations. Failure to install appliances correctly could lead to prosecution. It is in your own interest, and that of
safety, to ensure that the law is complied with.
Read these instructions carefully before attempting to operate the appliance. Comply with all applicable warn-
ings. Do not interfere with any sealed components, and use the appliance only in accordance with these
instructions.
INTRODUCTION
The MORCO FEB-24ED 3 is wall hung, room sealed, fan assisted, microprocessor controlled, fully modu-
lating gas combination boiler for providing both central heating and domestic hot water.
DOMESTIC HOT WATER SERVICE
Turn the right knob (DHW) in order to turn the boiler on. The display will show "On" indicating that the boiler
is ready to supply Domestic Hot Water (DHW) whenever there is demand for it. When a hot tap is opened the
boiler automatically
to deliver hot water and the orange light will come on indicating the burner is on. A
water temperature of between 35° and 60° C can be selected by turning the domestic hot water temperature
regulating knob. The value selected will be shown in the display when it is changed with the knob.
HOT WATER AND CENTRAL HEATING SERVICE
With the main control switch on and the display showing “On”,
turn the heating selector knob clockwise from the summer set-
ting.. The boiler will
up automatically when either the time
clock/room stat or boiler stat calls for central heating, or a hot tap
is opened for hot water. If a hot tap is opened the boiler gives pri-
ority to hot water delivery with the central heating on standby
until the tap is closed.
The temperature of the radiators can be selected between 60ºC
and 85ºC by turning the knob. the value will be shown on the dis-
play.
Note: If the boiler has been
for under heating the temperature cannot be altered by the user
operating the control knob. Only the pre-set value set up by the installer will be available
1.- USERS INSTRUCTIONS
5
6
1
4
1.-Pressure gauge
2.-Heating service and heating temperature selector
3.-Main control, reset and D.H.W temperature selector
4.-Clock
5.-Orange light. Burner on
6.-Red light lock out
7.- Display (between both knobs)
3
2
7
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Morco FEB-24ED at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Morco FEB-24ED in the language / languages: English as an attachment in your email.

The manual is 3,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info