646347
12
Zoom out
Zoom in
Previous page
1/23
Next page
12
INSTALLER
MAIN COMPONENTS:
1. FRAME including water heater hanging bar.
2. SEALED CHAMBER BASE, forming the combustion chamber together with the
cover.
3. FLUE EXTRACTOR UNIT equipped with an extractor body, fan, air pressure
switch and Ø 60-100 coaxial output.
4. FAN for removing combustion gases via the Ø 60 pipe and allowing air from
outside to enter the chamber.
5. HEAT EXCHANGER made of copper.
6. BURNER made of stainless steel with distribution manifold equipped with
injectors in accordance with gas type.
7. ELECTRODES for ignition and ionisation flame sensor.
8. GAS VALVE equipped with two safety valves, manual power selection,
automatic power modulation depending on water flow and progressive
burner ignition.
9. WATER VALVE equipped with automatic water flow regulator and manual
temperature selector.
10.POWER SUPPLY AND CONTROL: Supplies heater with 1.5 V from a 220-230
V
AC
mains voltage. Supplies fan and controls removal of combustion products
via the air pressure switch.
11.ELECTRONIC CIRCUIT for ignition and ionisation flame control.
12.AIR PRESSURE SWITCH which cuts off gas flow to burner in case of fan
malfunction
13.Ø 60-100 COAXIALFLUE SPIGOT
14.SUPPLY CABLE
15.WATER FLOW SWITCH: a safety device to prevent the gas water heater ope-
rating if there is no water flowing.
16. THERMISTOR (NTC): To measure the temperature of hot water outlet.
1-10.010.649-ingles:1-10.005.856-ingles 24/03/14 17:42 Página 12
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Morco F-11 EL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Morco F-11 EL in the language / languages: English as an attachment in your email.

The manual is 3,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info