16
• For best results, try to keep OutRide clear of
any cables that may rattle against it or appear
in your shot.
Mounting to Seatpost
Face it backwards to see what you’re leaving
behind, or maybe who’s right on your tail.
1. Remove the 1” DogBone extension by
loosening and removing the adjustment knob
and hex bolt at its base. Store these back in
the case when not in use for safe keeping.
2. Mount your OutRide to the top of the Bar Mount
using the adjustment post knob that came with
OutRide. Use the hex wrench provided with
OutRide to tighten if needed.
3. Loosen the adjustment knobs at the bottom
of the handlebar clamp until you can swing
one side free through the open slot in the
lower clamp.
4. Position the clamp on your seatpost where
there is sucient room for the clamp and your
ngers for tightening the knobs.
5. Tighten the knobs until snug, then adjust the
angle of OutRide.
6. Make sure to connect the leash to OutRide
and use the hook around the post and back to
the leash when riding.
