583594

Mobius ActionCam Manual

11
Zoom out
Zoom in
Previous page
1/15
Next page
Power On - Auto Record
If this parameter is set the Mobius will start recording as soon as external USB power is
connected or the camera is turned on. The type of recording depends on the Power On
Default setting:
Video Mode 1 and Video Mode 2: If a Time-lapse Video parameter is set the camera
will begin recording a time-lapse video. Otherwise it will start recording a normal
video.
Photo Mode: If a Time-lapse Photos parameter is set the camera will begin recording
a sequence of time-lapse photos. Otherwise it will take a single photo and then enter
standby mode.
Recording can be stopped and started manually by pressing the Shutter button. The
camera will normally be turned off when USB power is removed, but, assuming the
camera's internal battery has sufficient power, there will be a delay before the recording
stops. The dalay can be set to zero (immediate), 10 seconds or disabled. If power is
reconnected during this delay, the camera will resume normal operation.
Power-Off Disconnect
This parameter will have no effect unless Power On - Auto Record is set to either 'External
Mode' or 'Both'.
Power-on Delay
This parameter gives the user the choice of having a 2-3 sec. delayed power-up, or an
instantaneous power-up with no delay. Note that the system requires about 2 seconds after
power-on until the buttons become active.
USB Data Port Charging
Enables or disables charging the internal battery when USB is connected and the camera is
turned on.
•
When disabled, charging will only occur when the camera is turned off.
•
When enabled, charging will occur as soon as the USB is connected.
►This parameter should be set to 'Disabled' when the camera is used with hand held
devices in order to avoid draining the device's battery.
Audio Volume
When the volume is turned OFF, the sound track is completely eliminated from the video
output stream in the selected video mode and will free up a nominal 7% video recording
space.
Time Lapse Photos
If Time Lapse Photos is enabled, Motion Detection must be disabled. Time Lapse photos
are taken with the camera in Photo-Mode (red LED). The rear LED will not blink when
Photo Mode has been configured to take Time-Lapse Photos with a time interval of less
than 2 seconds. Likewise, when Time Lapse Photos has been set to less than 2
seconds, photos will always be recorded without a time stamp.
►Time-Lapse delays of less than 2 secs. will be permanently reset to a minimal delay of 2
seconds as soon as Photo Mode (red LED) is selected on the camera with a Video-Out
monitor connected and a picture taken. You will need to set the parameter again if you wish
to restore the original value.
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mobius ActionCam at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mobius ActionCam in the language / languages: English as an attachment in your email.

The manual is 0,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info