16
6. ENROLMENT OF NEW TAGS
Tags are used for switching on and off and to enter the program mode. The
supplied tags are already enrolled and therefore ready-to-use. If additional
tags are provided, they must be enrolled by the user. To enrol a new tag,
the communication module needs to be on (program mode).
1. Press the button on the back for 5 seconds. The LED will first flash
green/red, then quickly flash green and then remain green.
2. Send following SMS command to the device’s phone number:
1111 TAG 1111 stands for the security code (factory setting)
mind the space after the code
A short melody confirms the correct command and indicates the tag
enrolment mode. The tag reader turns red (for 15 seconds).
3. Now hold a new tag to the tag reader at the bottom of the detector.
The detector confirms the successful enrolment of the new tag by
beeps. The number of beeps represents the tag number (the first tag
beeps once, the second tag twice, etc.). If a tag was enrolled before, the
beeps will sound to indicate the tag number; it will not re-enrol.
The detector leaves the enrolment mode if no tag was hold against the tag
reader for 15 seconds.
A tag can be enrolled on multiple Mobeye MiniPirs, allowing it to operate
multiple devices. 25 tags can be enrolled per device.
To delete a certain tag, first check the memory position by the enrolment
procedure. Once in program mode, send following SMS command to the
telephone number in the device to delete a tag:
SMS command to delete tag x (replace x by the number of the tag):
CODE DELTAG:3
example: 1111 DELTAG:3
mind the space after the code
