599485
12
Zoom out
Zoom in
Previous page
1/15
Next page
12
CLEANING THE AIR OUTLET AND FAN OF THE INDOOR UNIT
Before cleaning
Switch the indoor unit off with the remote
controller and disconnect the power supply
plug and/or turn off the breaker, otherwise you
may get injured since the fan of the indoor unit
rotates at high speed during operation.
Cleaning
1
Manually move the horizontal vane to the end towards you, and make sure the fan has stopped.
Upward
.
2
Remove the horizontal vane. Be sure to hold horizontal vane when unlocking the stoppers.
Follow the procedure, 11
11
1 and 22
22
2 , to remove the horizontal vane.
1
2
Stopper
U
nlock
.
U
nlo
c
k.
Lo
c
k.
Ri
g
h
t
3
Swing the vertical vanes out one by one.
11
11
1Holding the unit lightly with one hand, grab
the tab of each vertical vane with the other
hand and pull it downward to swing out each
vertical vane.
22
22
2Hold the tab of each vertical vane and move the
vertical vanes in the directions of the arrows.
The vanes cannot be removed.
Swin
g
to the left
.
Swin
g
to the ri
g
ht
.
P
u
ll
towar
d
s
y
ou
.
T
a
b
C
annot b
e
r
e
mov
ed.
Be sure to hold the tab to swing out the vertical vanes, otherwise the vanes can be damaged.
Do not use excessive force to the fan guard during this procedure. The fan guard may be deformed
and the vanes may not work properly.
4
Clean the air outlet and fan of the indoor unit. (Make sure the fan has stopped.)
Be careful not to injure your hands.
If the air outlet or fan is dirty, moldy, or dusty, clean with a wet or dry soft cloth or with the brush of QUICK
CLEAN KIT which is installed to a vacuum cleaner. If the dirt is noticeable around the air outlet, clean with
a cloth soaked in a solution of mild detergent diluted in lukewarm water.
Please refer to the instructions described in QUICK CLEAN KIT for the details of the way to clean with the
brush of QUICK CLEAN KIT.
Do not use gasoline, benzine and polishing powder.
Do not use excessive force to the fan. Otherwise, it may be cracked.
G
roov
e
1
2
Stopper
In
se
rt thi
s
e
n
d
fir
s
t
.
L
e
f
t
Lo
c
k
.
5
Put the vertical vanes back to their original positions one by one.
22
22
2
Push each vertical vane until it clicks into place.
11
11
1
Hold the tab of each vertical vane and insert the
vertical vanes into their respective grooves.
Be sure to hold the tabs to install the vertical vanes, otherwise the vanes can be damaged.
Do not use excessive force to the fan guard during this procedure. The fan guard may be deformed and
the vanes may not work properly.
Put the vertical vanes back correctly to their original positions. Otherwise, condensed water may drip
down from the indoor unit or the horizontal vane could malfunction.
6
Install the horizontal vanes. (Reverse the removal procedures.)
Insert the power supply plug into the power outlet and/or turn on the breaker.
Check that all LED lamps are not blinking.
If they are blinking, the horizontal vane is not installed correctly.
In this case, disconnect the power supply plug and/or turn off the breaker, and then reinstall the horizontal vane by
following the procedures in step
6
.
If you operate the air conditioner after cleaning the air outlet and fan, do not get close to the air outlet as
any remaining dirt may be discharged.
After Cleaning
In procedure 22
22
2 lock the stoppers until they click into place.
SG79Y404H03 6/14/06, 10:14 AM12
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mitsubishi MSZ-GA25VA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mitsubishi MSZ-GA25VA in the language / languages: English as an attachment in your email.

The manual is 1,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info