617123
345
Zoom out
Zoom in
Previous page
1/434
Next page
Engine overheating
8-4 For emergencies
8
8. Start the engine in the vehicle providing
the boost. Let the engine idle a few min-
utes, then start the engine in the vehicle
with the low battery.
9. After the engine is started, disconnect the
cables in the reverse order from the way
you connected them.
10. For vehicles equipped with turbocharger,
install the battery upper cover and then
the air duct.
(Refer to “Removing and installing the
battery upper cover” on page 9-14.)
If you drive your vehicle with a low battery
charge, after the engine has been started by
using jumper cables, the engine may misfire.
This can cause the anti-lock braking system
warning light to blink on and off. This is only
due to the low battery voltage. It is not a
problem with the brake system. If this hap-
pens, fully charge the battery and ensure the
charging system is operating properly.
N00836500323
When the engine has overheated, the infor-
mation screen in the multi-information dis-
play will be interrupted and the engine
coolant temperature warning display will
appear. The screen will then change to the
engine coolant temperature display screen
and “ ” will flash. If this happens:
1. Stop the vehicle in a safe place. Turn on
the hazard warning flashers.
2. With the engine still running, carefully
raise the engine hood to vent the engine
compartment.
3. Check that the cooling fan is running. If
the fan is not turning, stop the engine
immediately and contact an authorized
Mitsubishi Motors dealer or a repair facil-
ity of your choice for assistance.
4. If you see steam or spray coming from
under the hood, turn off the engine.
NOTE
If the engine is started with the air duct
removed, the noise produced as air is drawn
into the engine will be greater than when the
duct is installed.
WARNING
Charging your battery while it is still in
your vehicle might cause the battery to
catch fire and explode. If you have to
charge it while in the vehicle, disconnect
the negative terminal.
Keep sparks, cigarettes and flames away
from the battery because the battery may
explode.
Keep your work area well vented when
charging or using the battery in an
enclosed space.
Remove all the caps before charging the
battery.
Electrolyte (battery acid) is corrosive
diluted sulphuric acid. If electrolyte comes
in contact with your hands, eyes, clothes,
or the painted surface of your vehicle,
thoroughly flush with water. If electrolyte
gets in your eyes, flush them immediately
and thoroughly with water, and get
prompt medical attention.
Always wear protective clothing and gog-
gles when working near the battery.
Keep the battery out of the reach of chil-
dren.
As your vehicle has anti-lock
brakes
WARNING
Engine overheating
WARNING
To avoid personal injury, keep hands, hair,
jewelry and clothes away from the cooling
fan. The cooling fan can start at any time.
345


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mitsubishi Lancer - 2014 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mitsubishi Lancer - 2014 in the language / languages: English as an attachment in your email.

The manual is 60,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info