Manual Mitsubishi Lancer - 2014 (page 89 of 434) (English)

617123

Zoom out

Zoom in

1/434

Free-hand Advanced Security Transmitter (F.A.S.T.-key) (if so equipped)

5-22 Features and controls

5. While pushing the ignition switch from

“LOCK” (PUSH OFF) to “LOCK”

(PUSH ON), set the ignition switch to the

“ON” position and confirm that all warn-

ing lights and warning displays are oper-

ating properly.

6. Without pressing the accelerator pedal,

slowly turn the ignition switch to the

“START” position to start the engine.

Release the ignition switch when the

engine starts.

After several attempts, you may experience

that the engine still does not start.

1. Make sure that all electric devices, such

as lights, air conditioning blower and rear

window defogger, are turned off.

2. While depressing the brake pedal on vehi-

cles equipped with continuously variable

transmission (CVT) or Twin Clutch SST

or the clutch pedal on the vehicles

equipped with manual transaxle, press the

accelerator pedal halfway and hold it

there, then crank the engine. Release the

accelerator pedal, immediately after the

engine starts.

3. If the engine still will not start, the engine

could be flooded with too much gasoline.

While depressing the brake pedal on vehi-

cles equipped with CVT or Twin Clutch

SST or the clutch pedal on the vehicles

equipped with manual transaxle, push the

accelerator pedal all the way down and

hold it there, then crank the engine for 5

to 6 seconds. Return the ignition switch to

the “LOCK” position and release the

accelerator pedal. Wait a few seconds, and

then crank the engine again for 5 to 6 sec-

onds while depressing the brake pedal or

the clutch pedal, but do not push the

accelerator pedal. Release the ignition key

if the engine starts. If the engine fails to

start, repeat these procedures. If the

engine still will not start, contact your

local Mitsubishi Motors dealer or a repair

facility of your choice for assistance.

When the ambient temperature is -4°F

(-20°C) or lower on vehicles with CVT, or

-22°F (-30°C) or lower on vehicles with Twin

Clutch SST, it may not be possible to start

from a standstill even with the selector lever

(CVT) or the gearshift lever (Twin Clutch

SST) in the “D” (DRIVE) position.

This phenomenon occurs because the trans-

axle has not warmed up sufficiently; it does

not indicate a problem. If this occurs, place

the selector lever (CVT) or the gearshift lever

(Twin Clutch SST) in the “P” (PARK) posi-

tion and let the engine idle for at least 10 min-

utes.

The transaxle will warm up, and you will be

able to drive normally.

Do not leave the vehicle during warm-up

operation.

NOTE

 Minor noises may be heard on engine start-

up. These will disappear as the engine warms

up.

When the engine is hard to start

Startability of continuously variable

transmission (CVT) vehicles or Twin

Clutch SST vehicles at extremely cold

ambient temperature

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Mitsubishi Lancer - 2014 in the language / languages: English as an attachment in your email.

The manual is 60,3 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Mitsubishi Lancer - 2014 Manual

Product: