617123
88
Zoom out
Zoom in
Previous page
1/434
Next page
Free-hand Advanced Security Transmitter (F.A.S.T.-key) (if so equipped)
Features and controls 5-21
5
If the engine will not start because the bat-
tery is weak or discharged, refer to
“Jump-starting the engine” on page 8-2
for instructions.
A longer warm up period will only con-
sume extra fuel. The engine is warmed up
enough for driving when the bar graph of
the engine coolant temperature display
starts to move. Refer to “Interrupt display
screen (With ignition switch in the “ON”
position)” on page 5-121.
On vehicles equipped with the Twin
Clutch SST, the following may occur after
the engine is started, but they do not indi-
cate an abnormality.
You may hear operational sounds of the
Twin Clutch SST and you may feel
vibration in the vehicle body.
If you shift the gearshift lever into the
“N” (NEUTRAL) position and depress
the accelerator pedal, increases in the
engine speed will be limited.
Your vehicle is equipped with an electroni-
cally controlled fuel injection system. This is
a system that automatically controls fuel
injection. There is no need to depress the
accelerator pedal when starting the engine.
The starter motor should not be run for more
than 15 seconds at a time.
To prevent battery drain, wait a few seconds
between attempts to restart the engine.
1. Make sure all occupants are properly
seated with seat belts fastened.
2. Press and hold the brake pedal down with
your right foot.
3. Press and hold the clutch pedal all the way
down (manual transaxle).
4. On vehicles with manual transaxle, place
the gearshift lever in the “N” (Neutral)
position.
On vehicles with continuously variable
transmission (CVT) or Twin Clutch SST,
make sure the selector lever (CVT) or the
gearshift lever (Twin Clutch SST) is in the
“P” (PARK) position.
WARNING
Never run the engine in a closed or poorly
ventilated area any longer than is needed
to move your vehicle out of the area. Car-
bon monoxide gas, which is odorless and
extremely poisonous, could build up and
cause serious injury or death.
CAUTION
Do not push-start the vehicle.
Do not run the engine at high rpms or drive
at high speeds until the engine has had a
chance to warm up.
Release the ignition switch as soon as the
engine starts. Otherwise, the starter motor
will be damaged.
Starting the engine
NOTE
For models equipped with a manual trans-
axle, the starter will not operate unless the
clutch pedal is fully depressed (Clutch inter-
lock). This is a safety feature.
NOTE
On vehicles with CVT, the starter will not
operate unless the selector lever is in the “P”
(PARK) or “N” (NEUTRAL) position.
On vehicles with Twin Clutch SST, the
starter will not operate unless the gearshift
lever is in the “P” (PARK) position or the
gearshift lever is in the “N” (NEUTRAL)
position with the brake pedal depressed.
For safety reasons, start the engine in the “P”
(PARK) position so that the wheels are
locked.
88


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mitsubishi Lancer - 2014 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mitsubishi Lancer - 2014 in the language / languages: English as an attachment in your email.

The manual is 60,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info