Manual Minox DTC 1100 (page 21 of 35) (English, German, French)

625815

Zoom out

Zoom in

1/35

4140

Testing the Mobile Phone Network

1. Push the main switch (12) to “SET”.

2. The DTC 1100 is now in the Manual Release mode.

If a SIM card has been inserted, the camera will be-

gin searching for available mobile phone networks.

If the “Send Mode” has been switched to “Off”,

during the “ Mobile Service Setup” procedure, the

camera will not search for a network. If “Instant”

or “Custom” has been activated, you will see

“Searching for Network” in the display (8). As soon

as the DTC 1100 has found a network, you will see

the network’s name in the bottom of the display (8).

If a network could be found, you will see “Network

Not Found” and then “Login Failed”.

Note: If the camera is unable to find a network

after several attempts, either the network signal is

too weak or the SIM card you are using is not com-

patible with the DTC 1100.

3. Press the lower arrow key (11) in the “Manual

Control” mode or select “Playback Photo/Video” in

the “Camera Mode” menu option that is located

under the first tab “Camera Settings”. Use the LEFT/

RIGHT arrow buttons (11) to select the photo you

would like to send and push OK (11). You will see

“Sending” in the display (8). The photo will now be

sent to the predefined recipients. After the photo

has been successfully sent, you will see “Send

Over“ in the display (8) or “Send Fails” if the photo

could not be delivered.

Note: Depending on signal strength, the delivery of

the photo can take from 5 to 60 seconds. Sending

photos via SMTP always takes more time than via

MMS.

Mobile Service Settings using the

Camera Menu

As an alternative to the Download Tool, you can make

the basic SMTP settings directly with your DTC 1100

under the third tab.

Send Mode

Go to “Main Menu” by pressing the menu button (15)

and select the menu option “Send Mode”. This is lo-

cated under the third tab “Mobile Service Settings”.

Press the OK button (11) or the right arrow key (11)

to access the submenu. Here you can choose between

four modes:

1. Off

2. Instant

3. Customized

4. Daily Report

Use the UP/DOWN arrow buttons (11) to select the

mode you wish to use and push OK (11).

1. If “Send Mode” is off (see “Off”), the SMTP function

is deactivated and you cannot send photos via your

mobile phone network. The DTC 1100 will return to

the menu “Mobile service settings”.

2. Select “Instant” and verify with OK (11) to have

the photos sent immediately to the predefined re-

cipients after they have been taken. Use the UP/

DOWN arrow buttons (11) to define the maximum

number of photos that can be sent within the fol-

lowing 24 hours. Use the UP/DOWN arrow keys (11)

to define the number and confirm with OK (11).

Press the left arrow key (11) to return to the Start

menu without changing the settings. Press the

menu button (15) to return to “Manual Controls”

without changing the settings. If for example you

have defined 10, the first 10 photos made with the

DTC 1100 will be sent. Photos made in the follow-

ing 24 hours after the tenth photo will be saved on

the SD card and not be sent.

Note: It is not possible to send more than

200 photos per 24 hours.

3. Select “Customized” with OK (11) to define a

specific time when the photos should be sent and

the maximum number of photos to be sent during

the following 24 hours. To do this, push the UP/

DOWN arrow buttons (11) to set the desired unit

and the RIGHT and LEFT arrow buttons (11) to

change positions from hour to minutes. When you

have finished making your settings, push OK (11)

to save your setting or MENU (15) to exit without

saving. If for example you have set the time to

09:30 and “Daily Max” to 10, the first 10 photos

made with the DTC 1100 will be sent to the pre-

defined recipients at 09:30.

Note: The time can only be set in the 24 hour

format and the maximum number of photos that

can be sent cannot exceed 50.

4. Select “Daily Report” with OK (11) to have the

most important data sent to your mobile phone

per text message (SMS) at the set time. The report

contains for example the number of photos that

have been made during the previous 24 hours,

battery status and remaining memory space on

the SD card. To set the time at which the Daily

Report should be sent, push the UP/DOWN arrow

buttons (11) to set the desired unit and the RIGHT

and LEFT arrow buttons (11) to change positions

from hour to minutes. When you have finished

making your settings, push OK (11) to save your

setting or MENU (15) to exit without saving.

Note: The time can only be set in the 24 hour format.

Send Via

Your DTC 1100 offers you two options to send your

photos – either as an MMS or via SMTP. Go to “Main

Menu” by pressing the menu key (15) and select the

menu option “Send Via”. This is located under the

third tab “Mobile Service Settings”. Confirm with OK

(11). Depending on the phone card plan and options,

each MMS might be charged to your “normal” phone

bill, whereas files sent via SMTP will require a data

plan from your provider. For both options however, you

can specify multiple destinations. You can choose be-

tween “MMS” or “SMTP”. Make your selection and

push OK (11). If you have not defined the SMTP pa-

rameters using the “Download Tool” software, you

cannot select “ SMTP” in this menu. Push the LEFT

arrow button (11) to go back to the previous menu.

Send To

Go to “Main Menu” by pressing the menu button (15)

and select the menu option “Send to”. This is located

under the third tab “Mobile service settings”. Press

the OK button (11) or the right arrow key (11) to access

the submenu.

In the submenu, you can set the DTC 1100 to send

your photos to a telephone number, an email address

or to both. You can define up to 4 telephone numbers

and 4 email addresses. If you choose “Phone”, your

DTC 1100 will send the images to a maximum of

4 telephone numbers. If you choose “Email”, your

DTC 1100 will send the images to a maximum of

4 email addresses.

If you choose “Both”, your DTC 1100 will send the

images to a maximum of 4 telephone numbers and up

to 4 email addresses simultaneously. Push the LEFT

arrow button (11) to go back to the previous menu.

Note: If you choose the SMTP option, you can

send images only to email addresses and not to

telephone numbers – the options “Phone” and

“Both” are not possible.

Network Setup

Here you can define the telephone numbers and

email addresses to receive the photos sent from your

DTC 1100. You can also select your mobile phone

network provider. Go to “Main Menu” by pressing

the menu button (15) and select the menu option

“Network Setup”. This is located under the third tab

“Mobile service settings”. Press the OK button (11) or

the right arrow key (11) to access the submenu. In the

submenu that now opens, you can select between the

items “Recipient Phone”, “Recipient Email” and “Net-

work Provider”. Confirm your selection with OK (11).

Recipient Phone

If you have selected “Recipient Phone”, you can enter

up to four phone numbers in the submenu. Choose

a place holder (e.g. Phone 1) and press OK (11). You

can enter the desired telephone numbers using the

up/down arrow keys (11). The number is accepted by

pressing the right arrow key (11). If you have entered

the wrong number, use the left arrow key (11) to

delete the number. Press OK (11) to save. To go back

to the “Manual Controls” without saving the entries,

use the menu button (15).

Recipient Email

If you have selected “Recipient Email”, in order to

store email addresses, please follow the instructions

as described for saving telephone numbers. In this in-

put field, after selecting a placeholder (e. g. Email 1),

you can also select letters and characters in addition

to numbers.

Network Provider

In the menu option “Network Provider” you can select

from a list of preconfigured mobile phone providers

for your country. Use the up/down arrow keys (11)

to select your country and confirm with OK (11). You

will now see a list of preconfigured providers in that

country. Select your provider and press OK (11). If you

are in the country selection, press the left arrow key

(11) to return to the previous menu. To go back to

the “Manual Controls” from the list of mobile phone

providers and the country selection without saving

the entries, press the menu button (15).

Note: If your provider is not highlighted, please

follow the “Operator Parameter” instructions given

in the section “Mobile Phone Settings using the

Download Tool Software”.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Minox DTC 1100 in the language / languages: English, German, French as an attachment in your email.

The manual is 0,63 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Minox DTC 1100 Manual

Product: