727618
23
Zoom out
Zoom in
Previous page
1/32
Next page
Note:
Remember that in two cup mode, two brewing operations
are implemented in sequence and correspondingly, if a
pot is selected for four/eight cup mode, 4 or 8 brewing
operations are implemented. Only remove the cups or
potwhenallbrewingoperationsarenished.
During coffee preparation, the coffee powder is moiste-
nedwithasmallamountofwaterrstforpre-brewing.
The actual brewing process takes place after a short
pause.
Youcanstopcoffeedispensingprematurelybybriey
pressing OK (button 6). In the case of strongly uneven
oronlyone-sidedcupllingduring2-cupoperation,
check whether one or both coffee dispensing spouts are
blocked on the inside by foreign bodies (coffee bean or
similar).
Changing and storing the cup lling level in bean
mode:
The coffee machine is set for standard quantities by
default.However,youcansetthecupllinglevelindivi-
dually for each cup size. Proceed as follows:
- Press the button 4 repeatedly until the required cup
symbol for the desired ground coffee quantity is displa-
yed.
Note:
Thecupllinglevelforonecupisstoredduringthis
process. (Appliance must be set to one cup mode).
Place an appropriate cup under the coffee delivery spout
(Espresso cup, coffee cup or coffee mug).
Press key 5 repeatedly until the symbol for the required
coffee grinding quantity lights up.
Press OK (button 6) and keep it pressed until the desired
llingamountisreached.
Releasethebutton.Thenewcupllinglevelisnow
stored.
Note:
Repeat the procedure if you also wish to change the
llinglevelfortheothercupsizes.
All values remain stored even when the coffee machine
is switched off. Should you change your cup size, you
canadaptthecupllinglevelindividuallyatanytime.
Thestoredcupllinglevelsforeachindividualcupsym-
bol only applies in bean mode.
Preparing coffee with powdered coffee:
-Select the “coffee powder “ function by pressing the
button 5.
-The following symbol lights up in the display:
Note:
During preparation of coffee with powder, only one cup
can be prepared with powdered coffee.
The “ground coffee quantity” function is deactivated.
Therefore no information on the ground coffee quantity
appears on the display.
-Select the desired cup size by pressing the button 4.
The following selections are possible:
-Open the lid of the coffee bean container (M) and the
coffee powder shaft (J)
-Pour in the fresh coffee powder.
-Then close both lids again.
CAUTION:
Ensure that powder does not clog the container and that
no foreign matter gets into the container.
Neverllthecontainerwithmorethanonelevelmeasu-
ring spoon of coffee powder.
Thellingcontainerisnotastoragecontainer;thepow-
der must be transported directly to the brewing unit.
-Place a cup under the coffee dispensing spout.
-In order to reduce heat loss and splashing, adjust the
height of the dispenser to suit your cup size by moving it
up or down.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Minimoka CM-4758 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Minimoka CM-4758 in the language / languages: English, Spanish as an attachment in your email.

The manual is 2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info