98984
27
Zoom out
Zoom in
Previous page
1/40
Next page
Problem solving guide
Despite adequate water supply press-
ure, the machine takes a long time to
fill.
Clean the filters in the water inlet sys-
tem as described on page 25.
Large amounts of unused detergent
remain in the dispenser drawer.
Water supply pressure is too low.
Clean the filters as described on
page 25.
Select the “Water plus” function if
necessary.
Washing powder becomes viscous
when used together with a water sof-
tener.
In future pour washing powder into
the detergent dispenser before ad-
ding water softener.
Fabric conditioner is not completely
dispensed or water remains in the
compartment p .
The dispenser drawer was opened
while fabric conditioner was being
flushed in.
The siphon tube is either incorrectly po-
sitioned or clogged. Clean as de-
scribed on page 22.
Excessive build-up of foam
To avoid this problem from the outset,
take note of the following points:
Follow the manufacturer’s dosage
recommendations on packaging
carefully.
Take the water hardness level into ac-
count.
For lightly soiled articles or a small
load, reduce the amount of deter-
gent accordingly.
Pre-soaked items should be rinsed
thoroughly before washing.
The “Pre-wash” indicator lamp is
flashing.
Start the programme again.
If the indicator still flashes call the Ser-
vice Department.
The “Main wash” indicator lamp
flashes during, or after the end of a
programme.
If this occurs again with the next pro-
gramme there is a technical fault. Call
the Service Department.
Laundry is either not spun at all or
not spun satisfactorily.
The selected spin speed was too low.
The machine was not able to distrib-
ute the laundry load evenly. To pro-
tect the machine, laundry was either
only spun at a reduced speed or not
at all.
Large items which tangle or roll up in
the drum (e.g. bath mats) can cause
an imbalance during the spin cycle.
For safety reasons, the machine
does not spin if this is the case. At-
tempts to build up spin speed are re-
peated, however, until the time allo-
cated to spinning has expired.
It is therefore important to make up
mixed loads consisting of large and
small items.
The fluff filter may be clogged.
Clean the filter and the pump as de-
scribed on page 23-24.
27
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Miele W 820 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Miele W 820 in the language / languages: English as an attachment in your email.

The manual is 1,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Miele W 820

Miele W 820 User Manual - German - 48 pages

Miele W 820 User Manual - Dutch - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info