666798
32
Zoom out
Zoom in
Previous page
1/76
Next page
Electrical connection
The electrical components of this dryer comply with
IEC 335-1, IEC 335-2-11 and IEC 335-2-40.
Electrical connection may only be carried out by a
suitably qualified technician in strict accordance with
local and national safety regulations (BS 7671 in the
UK).
Please observe the wiring diagram supplied.
Please ensure that the voltage and frequency of the
dryer as quoted on the data plate comply with the
on-site supply.
(EL) Electrical connection, (SLA) Peak load cut-out
Connection should be made via a suitable isolator
which complies with local and national safety
regulations and which is easily accesible for
disconnecting the dryer from the electricity supply.
Provision must be made on site to switch off all poles.
Switches with a minimum all-pole contact gap greater
than 3 mm are suitable for isolating the dryer. These
include circuit breakers, fuses and relays (IEC/EN
60947).
If the dryer is disconnected from the electricity supply
ensure adequate measures are taken to ensure that it
cannot be reconnected to the electricity supply until
all work has been carried out.
After the dryer has been connected to the electricity
supply check the phase rotation of the compressor.
,
In the case of incorrrect phase rotation, a loud
buzzing noise will be heard. Incorrect rotation of
the compressor will cause damage to the unit and
it must be shut down immediately.
Intake air, room air
(AL) Exhaust air, (ZL) Intake air, (KA) Condensate
drain
The dryer may only be operated in a room where
sufficient cool, fresh air is available. If the ambient
temperature is constantly above 45 °C, the circulatory
system of the heat pump unit should be connected to
a fresh air supply and the exhaust air should be
extracted externally.
Condensate drain
The heat pump tumble dryer is a condenser dryer.
Condensate is drained separately via a drain in the
base.
The condensate drain C 40 mm is located at the rear
of the heat pump unit and can be connected to a
floor gully by means of a hose or pipe with a gradient.
,
After setting up and connecting the dryer and
heat pump unit, ensure that all outer casing parts
are correctly fitted back into position.
Installation and connection
32
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Miele Professional PT 8337 WP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Miele Professional PT 8337 WP in the language / languages: English, Dutch as an attachment in your email.

The manual is 1,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info