738472

Midland M10 Manual

11
Zoom out
Zoom in
Previous page
1/35
Next page
6 | M-10 Instruction Guide M-10 Instruction Guide | 7
REPLACING FUSE
If you replace the fuse for DC power Cord, use F 5A 250V type. The parameters
and the symbol of the fuse are indicated in the following label.
HOW TO OPERATE
WITH YOUR TRANSCEIVER
1. Screw the microphone plug into the microphone jack.
2. Make sure your antenna is securely connected to the antenna connector.
3. Make sure the SQUELCH control is turned fully counterclockwise.
4. Turn on the unit and adjust the volume control.
5. Select your desired channel.
6. To transmit, press the PTT button and speak in a normal tone of voice.
7. To receive, release the PTT button.
SQUELCH
The squelch function cuts out annoying background noise when no signal is being
received. To do this, set the channel selector to a channel where no signals are pre-
sent or wait until signals cease on your channel.
Midland M-10 is supplied with two types of squelch: manual and automatic.
Manual: rotate the squelch knob in a counter-clockwise direction and stop before
you hear a ‘clic’, then rotate it clockwise to the point where the background noise
just stops. Do not set the squelch too high, otherwise weak signals will not be able
to open the squelch circuit.
Automatic: rotate completely the squelch knob counter-clockwise and stop after
you will hear a ‘clic’ . Now the squelch will be automatically adjusted according to
the background noise.
REMOTE SPEAKER
A speaker rated at 3-10 watts should be used for this function. Plug the speaker into
the EXT jack on the rear of the transceiver. When the external speaker is plugged in,
the internal one is disconnected.
FREQUENCY BAND SELECTION
The frequency bands must be chosen according to the country where you are going
to operate.
Procedure:
1. Turn o the radio
2. Switch on the transceiver while keeping pressed the UP/DOWN buttons at
the same time
3. Push the UP/DOWN buttons and select the desired frequency band (see the
chart here below)
4. Press the PTT button on the microphone to confirm your selection
Note1: in the UK frequency band it is possible to select directly the EC or EN frequency
bands by moving the AM/FM (EC/EN) selector.
Note2: if you select a frequency band operating in FM only, the AM/FM selector will
be useless.
F5A 250V +
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Midland M10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Midland M10 in the language / languages: English, German, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 1,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info