684504
11
Zoom out
Zoom in
Previous page
1/22
Next page
8
Installation & Owner's Manual
4.1 Water affusion before operation
Before using this unit, please follow the steps below.
Water Affusion: If the unit is used for the first time or used again after
emptying the tank, please make sure that the tank is full of water
before turning on the power.Method: see Fig.4-1
Water Affusion
Hot water outlet
Close
Water out
When water flows out from the water outlet,
the tank is full. Turn off the hot water outlet
valve and water affusion is finished.
Open
Open the cool water inlet valve and the hot
water outlet valve.
Cool water inlet
Hot water outlet
Open
Fig.4-1
3.4.4 Electrical Connections
varnish removers, refrigerants, and many other
commercial and household products. In addition excessive
dust and may affect the operation of the unit and require
frequent cleaning.
The ambient air temperature must be above -7ºC and
below 43ºC.If the ambient air temperature falls outside
these upper and lower limits the electrical elements will be
activated to meet the hot water demand.
3.4.2 Water System Piping
PRT(Temperature and pressure relief valve) properly
installed with a discharge pipe run to an adequate drain
and sheltered from freezing.
All piping properly installed and free of leaks.
Unit completely filled with water.
Tempering valve installed per manufacturer’s instructions.
3.4.3 Condensate Drain Line Installation
Must be located with access to an adequate drain or
condensate pump.
Condensate drain lines installed and piped to an adequate
drain or condensate pump.
The water heater requires 230 VAC for proper operation.
Wiring size and connections comply with all local applicable
codes and the requirements of this manual.
Water heater and electrical supply are properly grounded.
Correctly sized overload fuse or circuit breaker protection
installed.
3.4.5 Post Installation Review
Understand how to use the User Interface Module to set the
various modes and functions.
Understand the importance of routine inspection/maintenance
of the condensate drain pan and lines. This is to help
prevent any possible drain line blockage resulting in the
condensate drain pan overflowing.
IMPORTANT: Water coming from the plastic shroud is an
indicator that both condensation drain lines may be blocked.
Immediate action is required.
To maintain optimal operation check, remove and clean the
air filter.
Fig.4-2
Emptying
Drainpipe shut-off valve
Close
After emptying, please replace the nut of
drainpipe.
Close
Open
Drainpipe shut-off valve
Open
Cool water inlet
Close the cool water inlet valve, open the hot
water outlet valve and open drainpipe.
Hot water outlet
CAUTION
After powered on, the display lights up. Users can operate
the unit through the buttons under the display.
Emptying: If the unit needs cleaning, moving etc, the tank
should be emptied. Method: See Fig.4-2:
Operation without water in water
tank may result in the damage of
auxiliary E-heater. In case of such
damage, the manufacturer will not
be liable for any damages caused
by this issue.
4. TRIAL-RUNNING
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Midea RSJ-35 - 300RDN3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Midea RSJ-35 - 300RDN3 in the language / languages: English as an attachment in your email.

The manual is 2,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Midea RSJ-35 - 300RDN3

Midea RSJ-35 - 300RDN3 User Manual - Dutch - 27 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info