658486
23
Zoom out
Zoom in
Previous page
1/70
Next page
7
DL471 DSP
Operator Manual
Chapter 4: Getting Started
This chapter shows you how to connect up, switch on, set up and configure the
DL471 DSP unit.
Connecting up
Connect up the following to the rear panel of your DL471 DSP unit:
AES50: connect the cables from the AES50 audio sockets (bank 0 or bank 1)
from the X and Y routers to the appropriate AES50 audio X and Y sockets on the
unit.
Ethernet: connect the cables from the Ethernet control sockets on the X and Y
routers to the appropriate X and Y Ethernet control sockets on the unit.
Mains power supply: insert the IEC connector of the mains cable into the rear of
the unit and then plug it into the mains power outlet.
link: connect the ten DL471 DSP units together via the two 25-way sockets on the
rear panel of each unit (see “To daisy chain the DSP units” on page 44).
Switching the unit on/off
After you have connected up your DL471 DSP units, they are ready to be switched on.
To switch on a DL471 DSP unit, switch on the mains on/off switch on the rear of the
unit.
To switch off a DL471 DSP unit, press the mains on/off switch.
Setting up
Initial setting up of a DL471 DSP unit involves allocating an ID for it within the XL8
network system environment (see “To set up the unit’s ID number” on page 13).
Configuration
Configure the DL471 DSP unit to suit your operating requirements (see Chapter 5
“Programming Mode”).
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Midas DL471 DSP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Midas DL471 DSP in the language / languages: English as an attachment in your email.

The manual is 4,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info