813595

MicroTouch M29228 Titanium Solo Manual

6
Zoom out
Zoom in
Previous page
1/16
Next page
67
TRIMMING WITH ATTACHMENT
• Select one of the guides provided and place it on the blade,
ensuring both sides snap into place (Figure 6). The blade teeth
can face in either direction, depending on the area being shaved
and most comfortable way to hold the appliance.
• Turn on the appliance. Shave using a gentle, light motion.
• Always trim in the direction of the comb teeth, making sure that the
flat part of the attachment fully touches the skin.
• For optimal results, try various trimming positions (upwards,
downwards, or across) and move the shaving head against the grain.
• For best results, use when the skin and hair are fully dry.
PRECISE TRIMMING WITHOUT ATTACHMENT
• Use either of the two edges of the blade for sharp lines.
• Hold the MicroTouch Solo Titanium unit with the blade to the
skin, with only one edge actually touching the skin (Figure 7).
• Trim the beard with light and gentle movements.
CARE AND MAINTENANCE
Cleaning:
The MicroTouch Solo Titanium blade is fragile – please handle with care.
• If hair has built up on the attachment or blade, gently clean it
with the supplied brush.
• Do not rinse the blade. This can cause damage.
Removing the trimming attachment:
• Place your thumb on top of the trimming attachment (Figure 8)
and press down to remove it from the blade head (Figure 9).
• Lift off the trimming attachment (Figure 10).
Attaching the trimming attachment
Please make sure to place the desired attachment in the center
and let it snap into place with a click on both broad sides by lightly
pressing on it (Fig. 12).
Changing the blade:
For optimal results, replace the blade every 1-2 months, or when it
no longer provides the desired results.
• Remove any accessories.
• With the cover attached, gently push the blade release upwards and
remove the blade (Figure 11).
• Hold the new blade at the sides, and press it down onto the
handle until you hear a „click“.
• Remove cover before use.
NOTE: Make sure that the shaft is centrally aligned under the blade
head before it snaps into place. If the blade does not move when the
appliance is switched on after replacement, remove the blade, briefly
switch on the device without the blade, and replace it as described
in point 3.
FR
AVERTISSEMENTS
• N‘utiliser le rasoir qu‘à sec
• Ne pas rincer. N‘utiliser que la brosse pour
nettoyer la lame.
• Tenir hors de portée des enfants.
• Ne pas immerger le rasoir dans l‘eau ni dans
d‘autres liquides quand la recharge de
l‘appareil est en cours.
• Ne pas immerger le rasoir dans l‘eau ni dans
d‘autres liquides.
• Débrancher l‘appareil avant le nettoyage/
l‘utilisation et retirer le câble d‘alimentation.
• Ne pas utiliser l‘égalisateur quand il est
branché.
• Cet appareil contient une batterie au lithium-
ion. L‘éliminer conformément aux
réglementations fédérales, nationales et
locales.
• Ne pas jeter au feu.
• Le MicroTouch Solo Titanium ne peut pas être
utilisé sur les peaux sensibles ou irritées.
• Toujours examiner l‘appareil avant utilisation.
N‘utilisez pas l‘appareil s‘il est endommagé en
raison du risque de blessures.
• Cet appareil peut être utilisé par des enfants
dès 8 ans ainsi que par des personnes ayant
des capacités physiques, sensorielles ou
mentales réduites ou manquant d‘expérience
et de connaissances, s‘ils sont sous
supervision ou formés à une utilisation sûre
de l‘appareil et ont compris les dangers qui
en découlent.
MISE EN SERVICE
REMARQUE : testez la lame avant la première utilisation sur une
petite partie de votre bras ou de votre jambe. Si des réactions de
sursensibilité ou d‘allergie apparaissent, arrêter immédiatement
l‘utilisation. Prudence sur les parties sensibles comme les oreilles
pour éviter de s‘égratigner et de se couper.
RECHARGE
• Avant l‘utilisation, assurez-vous que l‘appareil est entièrement
rechargé.
• Brancher l‘extrémité étroite du câble de recharge dans le
MicroTouch Solo Titanium et la grande fiche dans une prise USB
(illustration 1) (adaptateur non incluses). La première charge et les
recharges durent environ 4 heures.
• Pendant la recharge, la LED d‘affichage du courant brille en
ROUGE (illustration 2). Le voyant s‘éteint dès que l‘appareil est
entièrement rechargé.
• Entièrement rechargé, le MicroTouch Solo Titanium a une
autonomie d‘environ 45 minutes. REMARQUE : quand la
puissance diminue, recharger l‘appareil.
UTILISATION
Le MicroTouch Solo Titanium a été conçu pour être utilisé pour la
barbe y compris les moustaches et les favoris.
• Le MicroTouch Solo Titanium est conçu UNIQUEMENT POUR
L‘UTILISATION À SEC. Ne pas l‘utiliser sous la douche.
• Si le couvercle de la lame est en place, l‘abaisser avant
l‘utilisation (illustration 3). ALLUMER et ÉTEINDRE le MicroTouch
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MicroTouch M29228 Titanium Solo at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MicroTouch M29228 Titanium Solo in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 0.97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info