441366

Metz 45 ct-1 Manual

4
Zoom out
Zoom in
Previous page
1/7
Next page
Now you can close the cover again.
Next step is to make the controller.
Bend the first seven contacts of the switch about 90 degrees in the outer direction.
Connect one end of the resistors with the contacts of the switch.
● Contact 1 – 2.2M ohm – Full power
● Contact 2 – 56K ohm - 1/2 power
● Contact 3 – 22K ohm - 1/4 power
● Contact 4 – 15K ohm - 1/8 power
● Contact 5 – 10K ohm - 1/16 power
● Contact 6 – 5,6K ohm - 1/32 power
● Contact 7 – 3,9K ohm - 1/64 power
Connect the other ends of the resistors with each other.
Take a piece of diode cable of approx. 30 inch and connect the male connector at one end.
On the other end make loose knot at about seven inches from the end.
Connect one wire with the middle contact of the switch and the other wire with the the place
where the resistors are connected with each other.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Metz 45 ct-1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Metz 45 ct-1 in the language / languages: Dutch as an attachment in your email.

The manual is 0,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info