441366
3
Zoom out
Zoom in
Previous page
1/7
Next page
Detach the small printboard.
Cut a piece of diode cable approx 5 inches and connect a female connector at one end.
Put the other end trough the hole (remove the small piece of transparent plastic).
Connect the two wires of the diodecable with the green and yellow wire.
eg. the center wire with the yellow wire and the outer wire with the green one or vice versa.
Make sure you shield the wires to avoid shortcuts. First i used thin shrinktubes to put over the
connected wires and a wider (red) piece of shrinktube to protect it all. This gives me a double
protection.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Metz 45 ct-1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Metz 45 ct-1 in the language / languages: Dutch as an attachment in your email.

The manual is 0,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info