658438
14
Zoom out
Zoom in
Previous page
1/88
Next page
14
ENGLISH
ENG
8.8 Removing the chuck
Geared chuck (1)
Undo the locking screw. THIS SCREW HAS A
LEFT-HANDED THREAD!
Hold the drill spindle tight with a spanner. With a
light blow from a rubber hammer, release the chuck
from the inserted chuck key and unscrew it.
Futuro Plus keyless chuck (2)
Undo the locking screw. THIS SCREW HAS A
LEFT-HANDED THREAD!
Hold the drill spindle tight with a spanner. With a
light blow from a rubber hammer, release the drill
chuck from the inserted hexagon wrench and
unscrew it.
Futuro Plus keyless chuck (3)
Unscrew the drill chuck with two open-end spanners.
In the case of deep bores pull the drill bit out of the
bore from time to time in order to remove the stone
dust or shavings.
The drill chuck can be removed for screw-driving.
Insert screwdriver bit directly into the spindle's
hexagon socket.
When the bit spring collet is attached, the
screwdriver bit is held in position.
For thread tapping, slightly oil the tap. Select low
speed and . Start cutting in clockwise direction,
stop and turn out in counter-clockwise direction.
Keyless chuck cleaning:
After prolonged use hold the chuck vertically, with
the opening down, and fully open and close it
several times. The dust collected falls from the
opening. The application of cleaning spray to the
jaws and jaw openings at regular intervals is
recommended.
If the trigger (8) can not be depressed, check to
see that the direction of rotation selector switch (9)
is fully set to the R or L position.
Electronic signal indicator (5)
(BE 1020)
Rapid flashing - restart protection
When power is restored after a power failure, the
machine - which is still switched on - will not start
for safety reasons. Switch machine on and off
again.
9Tips and Tricks
10 Servicing
11 Trouble Shooting
170267550_0208 BE 710.book Seite 14 Donnerstag, 31. Januar 2008 10:45 10
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Metabo BE 1020 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Metabo BE 1020 in the language / languages: All languages as an attachment in your email.

The manual is 4,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info