595131
17
Zoom out
Zoom in
Previous page
1/136
Next page
ENGLISH
17
ENG
Switch off the appliance, remove the mains plug
and open the snap locks (10). Remove the upper
part (9) from the container (11).
On the inside of
the suction
opening, push the
red rotary slide
with its "circle"
marking upwards.
(To twist the slide, push it slightly towards the
suction hose, and pull it back after twisting).
Hold the PE filter bag (6) on the flange and, with its
opening, guide it first over the latch at the bottom
part of the suction opening, then fit up to the stop
on the suction opening.8
Spread out the PE filter bag (6) evenly across the
container floor. Arrange the edges of the PE filter
bag around the container rim so that the bag is
firmly clamped on all sides by the upper part (5),
once replaced.
7.1 Switching On/Off,
Automatic
, Auto-
Clean
Select the required operating mode using the
switch (2)
:
Position "0":
Vacuum cleaner is switched off
Position "I":
Vacuum cleaner is switched on
AutoClean* is switched off
Position "IR":
Vacuum cleaner is switched on
AutoClean* is switched on
Position "AR":
Automatic On/Off switch: The vacuum
cleaner is switched on or off by means
of a power tool connected to the mains
socket (4). (Note: The vacuum cleaner continues to
run for approx. 10 seconds after the power tool is
switched off. This is to ensure that dust does not
remain in the hose.)
AutoClean* is switched on
* AutoClean
(Automatic Vibrate function): auto-
matic filter cleaning when you switch on the
appliance and when a specified vacuum value is
reached. For filters that remain clear, with no
need to interrupt work.
7.2 Power socket (4)
The power socket (4) is designed for
connection to a power tool only.
The total maximum permissible current
consumption (of vacuum cleaner and
connected unit) must not exceed the value I
max
(see table, page 2).
Caution! Ensure that the power tool is
switched off when plugging it in. Regardless
of the switch position, the plug socket is always
live when the mains plug is plugged in.
If the switch is (2) in the "0" position, you can use
the plug socket as an extension lead (e.g. for a light
fitting).
If the switch (2) is in the "AR" position, the vacuum
cleaner is switched on or off by means of a power
tool connected to the mains socket (4).
7.3 Suction control regulator
(ASR35
L
AutoClean only)
Using the suction power regulator (1), you can
adjust the motor speed and thus the suction power
continuously to the working conditions.
7.4 Volume flow control display
The volume flow control display lights up when the
container is full and/or if the suction hose is
blocked.
(3). In the case of ASR35M
AutoClean
,
an acoustic signal is also issued.
7.5 Rotary switch for setting the suction
hose diameter
(ASR35
M
AutoClean only)
Adjust the rotary switch (5) to the hose diameter of
the suction hose fitted.
The volume flow is being monitored if switch (2) is
at the "AR" or "IR" position.
If the volume flow falls below
a
set
value, the filter
cassettes (18) are automatically vibrated (without
any reduction in suction power). If the value still
remains too low, the
volume flow control display
lights up (in
switch position "AR"
an acoustic
signal is also sounded) to
indicate that the
container must be emptied, or that the paper filter
bag (8)/fleece filter bag (7) or the PE filter bag (6)
must be replaced
.
Ø 35 mm => 70 m³/h
Ø 27 mm => 40 m³/h
Ø 19 mm => 20 m³/h
Note:
If the suction hose diameter is 19 mm or less,
and if the flow conditions in the suction hose are
unfavourable, the
volume flow control display (3)
may occasionally light up and the acoustic signal
may sound, even though the paper filter bag/fleece
filter bag does not yet need to be emptied. In this
case, lay out the tube straight and clean it.
7 The Appliance
plastic
FFO
0
NO
A
I
NO
RI
R
I
RA
17027067_0711 ASR 35 L_M AutoClean ENTWURF.book Seite 17 Montag, 25. Juli 2011 4:46 16
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Metabo ASR 35 M ACP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Metabo ASR 35 M ACP in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 10,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info