Manual Metabo ASR 25 L SC (page 19 of 136) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish)

595126

Zoom out

Zoom in

1/136

ENGLISH en

8.4 Transport

In the case of the ASR 25 L SC / ASR 50 L SC, leave

the hose on the appliance to prevent dust acciden-

tally escaping.

In the case of ASR 50 M SC, seal the suction

opening (13) with a sealing plug (12) and join the

hose ends to prevent dust from escaping.

Wrap the suction hose about the vacuum cleaner.

Place the accessories in a suitable plastic bag and

seal the bag.

Suspend the mains connection lead on the

cable

holder

(11).

The upper part (8) must be securely sealed to the

container (10) - check that the snap locks (9) are

closed.

9.1 General Cleaning Instructions

Clean the container and accessories with water.

Wipe the upper part (8) with a damp cloth.

Caution! This appliance contains dust that is

harmful to health. Discharge and maintenance

operations (including disposal of the dust collection

containers) must only be carried out by qualified

specialists wearing appropriate protective clothing

and equipment.

Emptying the Container

Only permitted for dusts with

occupational exposure limits > 1 mg/m

- Unplug mains cable.

- ASR 50 M SC: remove suction hose, seal suction

opening (13) with sealing plug (12).

- Open the snap locks (9). Remove the upper part

(8) from the container (10).

- Tip out the container.

Dispose of the paper filter bag/fleece filter bag.

- Unplug mains cable.

-Pull on mask.

- ASR 50 M SC: remove suction hose, seal suction

opening (13) with sealing plug (12).

- Open the snap locks (9). Remove the upper part

(8) from the container (10).

- Carefully pull back and remove the paper filter bag

(7)/fleece filter bag (6) from the suction opening

(13). Seal the flange of the paper filter bag/fleece

filter bag by folding over the cover.

- Dispose of the vacuumed material in accordance

with legal regulations.

Disposing of the PE Filter Bag

-Insert mains plug.

- Switch on the vacuum cleaner and vibrate the

filters: turn the switch (1) to the "RA" position.

- Switch off the vacuum cleaner: turn the switch (1)

to the "0" position.

-Pull on mask.

- ASR 50 M SC: remove suction hose, seal suction

opening (13) with sealing plug (12).

- Open the snap locks (9). Remove the upper part

(8) from the container (10). Before setting down

the upper part, turn switch (1) to the "I" position so

that any falling dust is vacuumed.

- Carefully pull back the PE filter bag (5) from the

suction opening (13). Seal the flange of the PE

filter bag by folding over the cover.

- Dispose of the vacuumed material in accordance

with legal regulations.

9.2 Special cleaning instructions for

ASR 50 M SC

In the case of class M machines, the outside of the

machine should be cleaned (vacuumed and wiped

down), or treated with sealants before being removed

from the hazardous area. All machine parts must be

considered to be contaminated when removed from the

hazardous area: suitable measures must be taken to

prevent any dispersal of the dust. When carrying out

maintenance or repairs, it is essential to dispose of any

contaminated objects that cannot be adequately

cleaned. These objects must be disposed of using imper-

meable bags and in accordance with the applicable regu-

lations for removing such waste.

10.1 General Instructions

Before performing any maintenance, always

switch off the machine and remove the mains

plug.

Clean the appliance (see section9.).

For maintenance by the user, the vacuum cleaner

must be taken apart, cleaned and maintained, to the

extent possible, without endangering maintenance

staff or other people.

Preventive Measures

Appropriate preventive measures include: cleaning

the appliance before disassembly; providing local

filtered forced ventilation where the vacuum cleaner

is disassembled; cleaning of the maintenance area

and providing suitable personal protective clothing

and equipment.

10.2 Reduction in suction power

If the suction power decreases, carry out the

following steps:

1. Clean the filter cassettes by activating the elec-

tromagnetic vibrator (set switch (1) to the "RA"

position).

2. Empty the container or replace the paper filter

bag (7)/fleece filter bag (6) or PE filter bag (5).

3. Replace the filter cassettes (17), or rinse them

under running water, dry them and then replace.

10.3 Renew the filter cartridges (17)

Shake the filter cassettes (17) once again before

replacing the filters by switching on the electromag-

netic vibrator (set switch (1) to the "RA" position).

Use a coin or a similar object to turn the locking

knob (15) on the locking bar (14) counter-clockwise

through 90° and push the bar (14) to the rear. Swing

up the hood and pull up the filter cartridges (17) to

remove them. Seal the removed filter cassettes

immediately in a dust-tight plastic bag and dispose

of them in accordance with regulations. Insert new

9. Cleaning

10. Maintenance

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Metabo ASR 25 L SC in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 9,56 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Metabo ASR 25 L SC Manual

Product: