Manual Metabo ASR 25 L SC (page 18 of 136) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish)

595126

Zoom out

Zoom in

1/136

ENGLISHen

the electronics system switches the vibrator

off for approx. 10 s.

ASR 50 M SC:

• If an average air flow rate of 20 m/s in the

hose system with a diameter of 35 mm is

undershot, the

volume flow control display

(2)

flashes to indicate that the paper filter bag

has to be changed or the vibrator has to be

actuated.

7.2 Power socket (3)

The power socket (3) is designed for connec-

tion to a power tool only.

The total maximum permissible current

consumption (of vacuum cleaner and

connected unit) must not exceed the value I

max

(see

table, page 2).

Caution! Ensure that the power tool is

switched off when plugging it in. Regardless of

the switch position, the plug socket is always live

when the mains plug is plugged in.

If the switch is (1) in the "0" position, you can use

the plug socket as an extension lead (e.g. for a light

fitting).

If the switch (1) is in the "RA" position, the vacuum

cleaner is switched on or off by means of a power

tool connected to the mains socket (3).

7.3 Volume flow control display

The volume flow control display lights up when the

container is full and/or if the suction hose is blocked.

(2). In the case of ASR 50 M SC, an acoustic signal is

also issued.

7.4 Rotary switch for setting the suction hose

diameter

(ASR 50

SC only)

Adjust the rotary switch (4) to the hose diameter of

the suction hose fitted.

The volume flow is being monitored if switch (1) is at

the "RA" or "I" position.

the

volume flow falls below a set value, the filter

cassettes (17) are automatically vibrated (without

any reduction in suction power). If the value remains

too low, the

volume flow control display lights up and,

switch position "RA"

an acoustic signal

is also

sounded to indicate that the container must be

emptied, or that the paper filter bag (7) / fleece filter

bag (6) or the PE filter bag (5) must be replaced

dia. 35 mm => 70 m³/h

dia. 27 mm => 40 m³/h

dia. 19 mm => 20 m³/h

Note:

If the suction hose diameter is 19 mm or less,

and if the flow conditions in the suction hose are

unfavourable, the

volume flow control display (2)

may

occasionally light up and the acoustic signal may

sound, even though the paper filter bag/fleece filter

bag does not yet need to be emptied. In this case,

lay out the hose straight and clean it.

Note:

If you need to turn the rotary switch to a lower

value because of a machine generating dust (e.g.

small diameter of suction canal in the machine

generating dust, compared to large suction hose

diameter) (4), there is no guarantee that dust will be

conveyed adequately in the suction hose. The

suction hose must be removed from the machine

generating dust after every operating sequence, so

it can be vacuumed clear.

8.1 Dry Vacuuming

Vacuum using a dry filter, dry appliance and dry

accessories only. If the cartridge is damp, dust may

stick and form a crust.

Always use filter cassettes when using paper filter

bags (7), fleece filter bags (6) or PE filter bags (5)

(17).

8.2 Wet vacuuming

Never operate the machine without inserting a

filter cassette first (17) The machine may be

destroyed and water may also escape.

Vacuum without a paper filter (7) bag. You can use

either fleece filter bags (6) or PE filter bags (5). The

filter cartridges (17) are suitable for wet vacuuming.

Before carrying out any wet vacuuming, remove the

dry vacuumed material. This process will prevent

severe soiling and encrustation.

The integrated water sensor switches off the motor

when the container is full. Empty the appliance. If

the appliance is not switched off, the restart protec-

tion device remains effective. The appliance is not

operable again until it has been switched off and

switched back on again.

After switching off, some water may run back out of

the hose.

Before emptying, first of all take the suction hose out

of the liquid.

If you are then going to dry vacuum, insert a dry

filter. If there is frequent switching between dry and

wet vacuuming, we recommend the use of a second

(replacement) filter. Allow the filter, container and

accessories to dry: otherwise dust may adhere to

damp components.

8.3 Special instructions for ASR 50 SC

Use as industrial vacuum cleaner (IS):

Turn switch (1) to the "RA" position.

Adjust the rotary switch (4) to a diameter of 35 mm.

If the volume flow falls below the set value

, the

volume

flow control display

lights up to indicate that the

container must be emptied, or that the paper filter

bag (7) /fleece filter bag (6) or the PE filter bag (7)

must be replaced

Use as a dust extractor (ENT):

The dust extractor must not be connected to more

than one dust source.

Turn switch (1) to the "RA" position.

Adjust the rotary switch (4) to the hose diameter of

the suction hose fitted. For more detailed informa-

tion, see section 7.4.

Connect the power tool (deactivated) to the plug

socket (3). See section 7.2.

8. Use

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Metabo ASR 25 L SC in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 9,56 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Metabo ASR 25 L SC Manual

Product: