797762
7
Zoom out
Zoom in
Previous page
1/156
Next page
7
After setting temperature under Cooling mode “K”, if you select again cooling mode “K” or Fan mode “M”, then LED display indicates
the default target temperature 25°C.
4. Adjust fan speed
Press the button "B" to select a desired fan speed shows by sequence:
Low speed "F" -> High speed G
5. Power
When you press the "A" button again, the device will sound "di" and stop working.
6. Press this button "N" to set a timer.
Modes working principles:
Dehumidify "L" mode:
1. The fan will run at low speed, and the speed can't be adjusted.
The adjustment of temperature is no effective. The device automatically adjusts the set temperature to 2°C below the room
temperature when entering the dehumidification mode.
2.When room temperature ≤ 16, cannot dehumidify, the fan will run at low speed.
WARNING:
When operating the device in conditions of varying humidity, the drain plug (8) should be constantly open and ensure constant water
drainage. To comfortable water draining use the pipe included in kit.
COOL "K" mode:
1. When the room temperature is higher than set temperature on control panel, the compressor starts to run. The device cools the
room.
2. When the room temperature is lower than set temperature on control panel, the compressor stop and the fan operates at original
set speed.
Fan "M." mode.
1. The fan runs at set speed, and the compressor does not run.
2. The adjustment of temperature is no effective.
Timer operation "N":
1. Press “N” button to set Automatic Off time while the unit is running.
2. Press “N” button to set Automatic On time while the unit is ready.
3. The time can be adjusted within a range of 1 hour to 24 hours by pressing the button "D"+or "E"-).
Notice:
The main control board has memory function, when the device is ready to run but in stop status, the main control board can
memorize the initialization of working mode. When you turn on the unit, it will work as the same enactment of working-mode as last
time, no need to reset the working mode again.
REMOTE CONTROLLER
1. Slide the back cover to open and take off the isolating film on the batteries.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mesko MS 7854 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mesko MS 7854 in the language / languages: All languages as an attachment in your email.

The manual is 19.91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info