494844
62
Zoom out
Zoom in
Previous page
1/75
Next page
55
CONFIGURING THE
DIGITAL SURROUND
CONTROLLER
Setting up sources
This section explains how to use Gain/Sub mode to set up the sources
connected to the digital surround controller, and confi gure them to suit
your other equipment.
You can also adjust the subwoofer crossover frequency to suit the
subwoofers in your system.
To turn on Gain/Sub mode
Put the digital surround controller into standby by pressing Off (front
panel or remote).
Press and hold the Confi gure key under the front panel for at least fi ve
seconds.
The display shows:
Gain/Sub On
The digital surround controller will then return to standby with Gain/Sub
mode turned on.
Gain/Sub mode adds two extra options to the DSP parameter menus:
Sensitivity and Xover.
To turn off Gain/Sub mode
Repeat the above procedure until
the display shows:
Gain/Sub Off
To adjust the sensitivity of a source
To obtain the best signal-to-noise ratio for your analogue sources you can
adjust the sensitivity of each input to give the highest level that does not
produce clipping.
Turn on Gain/Sub mode, as described above.
Select the source you want to adjust, with loud source material playing.
• Press < or > (remote or under the front panel) until the display shows
the current sensitivity.
For example:
Radio 2.0V In
• Press A or V (remote or under the front panel) to change the sensitivity.
62


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Meridian 861 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Meridian 861 in the language / languages: English as an attachment in your email.

The manual is 3,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info