494960
61
Zoom out
Zoom in
Previous page
1/70
Next page
53
Troubleshooting
Operational problems
There is no power
Is the power cord disconnected?
Insert the power cord (plug) properly.
Is the main power supply switch turned on?
Turn on the main power supply switch of the projector
unit.
Is the lamp in the cool down mode?
Turn on the power again after the cool down mode
ends.
Is the lamp protection function triggered? (This function
is triggered when the power shuts down such as during
power failures.)
Wait till the temperature of the lamp has gone down.
(Turn on the main power supply switch to run the fan
and cool down the lamp.) Turn on the power after
about 3 minutes.
Projector works when the power is
turned on, but stops abruptly after a
few minutes
Are the air inlets and vent holes blocked?
Turn off the main power supply switch, and remove
the blockage. After removing, turn on the power
again.
Is the temperature of the room high?
Set the temperature of the room or the surrounding
temperature of this projector to an appropriate level.
Are the filters dirty?
Clean the filters; see
Cleaning and replacing the
filters
, page 48.
The remote control does not change
the image settings
Check that the RS232 projector control connection
has been made between the Scaler and Projector.
Check that the Information menu on the OSD
Setup contains valid data. If the RS232 cable
between the Scaler and Projector is not connected
correctly the Information menu will display
Unavailable on items that require a response from
the Projector.
61


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Meridian 810 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Meridian 810 in the language / languages: English as an attachment in your email.

The manual is 1,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info