494960
38
Zoom out
Zoom in
Previous page
1/70
Next page
30
Setting up the 810
System
Stage 2: Projector settings
The Configuration Wizard provides access to the
essential projector settings, needed to obtain a visible
on-screen display.
Once these settings have been configured correctly,
further settings can be adjusted using the remote
control and on-screen display, as described in
Adjusting
the projector, page 36.
To configure the projector settings
Either:
Press Skip after resetting the product; see
Stage 1:
Resetting the product
, page 29.
Or:
Press Wizard; see
Configuration Wizard
, page 28.
Press Skip to skip past the Reset settings menu.
The display shows the title screen for stage 2:
%NTER 3KIP"ACK
0ROJSETTINGS
Press Enter to proceed or Skip to go to stage 3.
The display shows the first projector setting, Test
Pattern, and the current value of that setting, Off:
z{|wxy"ACK .EXT
4EST0ATTERN
3ET
/FF
Press Next or Back to step between settings.
The options are summarised in the table on the next
page.
To change a setting
Press A or V to step through the alternative values
for the setting.
To move to the next setting
Press Source.
When you have finished configuring projector settings:
Either:
Press Next on the last option of the last source
(Force Signal) to proceed to configuring settings, as
described in the next section.
Or:
Press Power to return to standby.
38


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Meridian 810 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Meridian 810 in the language / languages: English as an attachment in your email.

The manual is 1,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info