494939
35
Zoom out
Zoom in
Previous page
1/40
Next page
Setting up the analogue controller
31
Communication is not working
between the 502 Analogue Controller
and other Meridian products
Check that all products are interconnected using the correct
comms leads.
If the installation includes 200 Series or 600 Series units,
check that all 500 Series units are set to 200 mode.
A source cannot be copied to the tape
outputs
Check that you do not have the source set up as a Tape
source; see Configuring the sources, page 16.
There is interference on the radio and/
or television when the analogue
controller is switched on
Before following the steps below, ensure all units are switched
off.
If this equipment does cause or suffer from interference to/from
radio or television reception then the following measures should
be tried:
Reorient the receiving aerial (or antenna) or route the antenna
cable of the receiver as far as possible from the 502 Analogue
Controller and its cabling.
Ensure that the receiver uses well-screened antenna cable.
Relocate the receiver with respect to the analogue controller.
Connect the receiver and this product to different AC outlets.
35


Need help? Post your question in this forum.

Forumrules
1

Forum

meridian-502

Reset search

  • My Meridian 502 preamp has no power. I have replaced fuse and still no power. Fuse has not blown. Submitted on 16-2-2022 at 18:24

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Meridian 502 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Meridian 502 in the language / languages: English as an attachment in your email.

The manual is 0,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info