494939
26
Zoom out
Zoom in
Previous page
1/40
Next page
Customising the analogue controller
22
In addition to configuring the sources, and programming their
levels, you can configure many other aspects of the operation of
the 502 Analogue Controller to suit the way your system is set
up, and the way in which you want to use it.
Note that any settings that you configure are reset to standard
values when you choose one of the standard settings: see
Choosing standard settings, page 14.
To configure the analogue controller
Switch off the analogue controller, using the power switch on
the back panel.
Switch on the power again while holding down the Display
key on the front panel.
The display will show:
Config
It will then show the first
configuration option:
500
Press Display to move between the options.
Press A or V to change the value of the current option.
Specifying information about your system
The table below shows the options you can configure.
Option Initial Value
Communications mode (500 or 200)
500
Controller mode (Auto, Con., or N.Con.)
Auto
System address (1–8)
S.A. 1
Product address (1–8)
P.A. 1
Volume mode (M, S, or N)
Vol. M
Copy address (2-room) (1 to 8)
C.A. 2
Source info display (2-room) (Y or N)
Dis. N
These settings are configured automatically to appropriate
values when you choose one of the standard Type settings, and
you should not normally need to alter them; see Choosing
standard settings, page 14.
26


Need help? Post your question in this forum.

Forumrules
1

Forum

meridian-502

Reset search

  • My Meridian 502 preamp has no power. I have replaced fuse and still no power. Fuse has not blown. Submitted on 16-2-2022 at 18:24

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Meridian 502 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Meridian 502 in the language / languages: English as an attachment in your email.

The manual is 0,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info