657615
126
Zoom out
Zoom in
Previous page
1/139
Next page
122
5. Screw in the bolts which have a greased
thread and head by a few turns with your
fingers. Screw in all bolts by hand until
they are snug. The clamping slot between
stem cap and stem body must be even with
the same gap at either end.
Check whether the handlebar is firmly seated
in the stem by trying to turn the handlebar
downwards. Furthermore, check whether you
can twist the handlebar/stem unit against
the fork. Take the front wheel between your
knees and try to turn the handlebar against
the wheel.
If the clamping of the handlebar or stem is still
not tight, increase the torque until you reach
the upper limit of the torque setting given by
the stem manufacturer.
With regard to the necessary torques, see
chapter 29. Recommended torques for
bolted connections”
. If the torques for two
components to be combined differ, make it a
rule to tighten them to the lower torque.
Check the firm seat once again, as described
above. If the clamping of the handlebar into
the stem or the stem onto the fork stem is not
properly tight, there is a dimensional compat-
ibility problem. In this case the stem should be
replaced by a compatible one.
28.4 Carbon handlebars and stems
6. Tighten the bolts of both clamping areas
alternately and gradually with a torque
wrench until you reach the lower limit of
the recommended torque. In the case of
stems with a 4-bolt front clamp, tighten the
bolts diagonally.
126


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Merida 2008 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Merida 2008 in the language / languages: English as an attachment in your email.

The manual is 5,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info