672248
173
Zoom out
Zoom in
Previous page
1/204
Next page
173
ZH-
CN
排除故障
故障 原因 措施
咖啡只一滴滴流出。 研磨度过细。
将研磨度调粗。
清洁滤煮器。
也可以运行除垢或清洁程序。
不流出咖啡。
水箱无水或者未正确装好。 加满水箱并注意其正确位置。
滤煮器堵塞 清洗滤煮器。
研磨机不研磨。
咖啡豆未落入研磨机。 轻轻敲击豆槽。
研磨机中有异物 拨打热线电话。
研磨机发出异响 研磨机中有异物 拨打热线电话。
咖啡豆图标
闪烁,即使
已填装豆槽。
滤煮室内没有足够的磨好的
咖啡豆
按下单杯烹制量按键
或者双杯
的烹制量按键
显示屏上亮起
咖啡机内部管路里有空气。
加满水箱并按下咖啡浓度按键
排空咖啡机内的空气。
清洁或除垢程序被中断。 供电被中断,例如由于停电。
咖啡机自动运行冲洗程序。请遵照
咖啡机的说明操作。
滤煮器取出后无法再安装。
滤煮器未正确锁紧。
检查锁紧滤煮器的手柄是否正确啮
合。
驱动装置不在正确位置。
关闭然后重新打开咖啡机。同时按
下单杯和双杯烹制量按键
2 秒以上。驱动装置移动到正确位
置。然后再次装入滤煮器并检查锁
紧装置是否正确。
清洁图标 和待机图标
交替闪烁。
缺少滤煮器或者未正确安装。 正确安装滤煮器。
滤煮室过满。
使用开/关按键
关闭并再次打开
咖啡机(必要时重复操作),直至
显示待机模式。
所有操作键不停闪烁 系统错误
使用开/关按键
关闭并再次打开
咖啡机,如果无效,请将咖啡机寄
至服务中心。
BA_Solo_042015.indd 173BA_Solo_042015.indd 173 20.04.2015 21:31:0620.04.2015 21:31:06
173


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Melitta CAFFEO SOLO E950-111 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Melitta CAFFEO SOLO E950-111 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 3,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info