479169
34
Zoom out
Zoom in
Previous page
1/56
Next page
Equipment and cable installation
Equipment and cable installationEquipment and cable installation
Equipment and cable installation
This offers a general explanation of how to install the IDU and satellite receiver properly to
the inside of vessel connecting with coaxial cable.
1. The Coaxial cable is routed from the antenna to the IDU inside the vessel.
2. After Once deciding where to place the IDU and satellite receiver, make sure that both
units are placed in a dry and protected area.
3. The IDU and satellite receiver should be placed away from any heat source and in an
area with proper ventilation.
4. Ensure that there are at least 3cm of space around both units for ventilation and
connection of cables. Do not stack the units on top of each other.
5. The following describes the basic wiring configurations for the antenna system.
Connect the Coaxial cable to the antenna port on the back of the IDU
Connect one end of the supplied coaxial cable to the receiver port on the back of
the IDU
Connect the other end of the coaxial cable to the satellite receiver
Setting the LNB
Setting the LNBSetting the LNB
Setting the LNB skew angle
skew angle skew angle
skew angle (manual)
(manual)(manual)
(manual)
Figure 2-3 Satellite signals
Signals transmitted in vertical(red) and horizontal(blue) wave offset exactly 90º from each
other. Since linear satellite signals are oriented in a precise cross pattern, Free Way 1S
antenna’s receiving element, called an LNB (low-noise block) must be oriented in the same
way to optimize reception. This orientation adjustment is referred to as the LNB’s “skew
angle.” Figure 1-4 illustrates how skew determines the amount of signal the LNB collects.
The more signal, the better reception.
Figure
2
-
4 Best Skew Angle
Bad
skew
Good
skew
Best
skew
: LNB “signal collector”
: Satellite Signal
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Megasat Shipman WSTA-VM250P at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Megasat Shipman WSTA-VM250P in the language / languages: English, German as an attachment in your email.

The manual is 7,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info