479172
7
Zoom out
Zoom in
Previous page
1/23
Next page
Selecting the locationPreparing for the installation
Install Tools and Materials
1. Verication of the Vessel’s Power Supply.
2. Verication of the Satellite Receiver and IDU’s attachment and
the electricity supply
3. Procedure of the satellites attachment and installation.
Warnig!
The Seaman antenna system is designed for simple installation and setup. However,
the following list of equipment or items should be available during installation of the
Seaman antenna.
Determine the optimum mounting location for the antenna radome assembly. It
should be installed where:
Perform a through site inspection on the roof for the antenna to be mounted.
If these conditions cannot be entirely satised, the site selection will inevitably be a
“best compromise between the various considerations.
• Electric drill and drill bits
• Socket wrench
• Silicon sealant
• Fastener suitable for specic application
• Conrm that the vessel’s power supply is 12VDC~24VDC.
• Attach Satellite Receiver and IDU in the interior of the vessel or the trunk.
• Connect the power of Satellite Receiver and IDU.
• Once the power of Satellite Receiver and IDU is veried, it conrms that
both Satellite Receiver and IDU are working normally.
• Attach the satellite on the at surface area of the vessel’s roof.
• Connect each end of the Coaxial antenna cable to the satellites
terminal and the IDU.
• Connect the IDU and the Satellite Receiver box together through
the coaxial cable.
• Make sure that the satellite is working normally, once the power
is supplied.
• Turn o the power when attaching or detaching the antenna.
• Make sure that the attached satellite is xed on the at surface.
• When attaching, ensure that all the products are adhered properly.
• Ensure that all the cables are connected properly.
1. The antenna has a clear line-of-sight view to as much of the sky as is practical.
Choose a location where masts or other structures do not block the satellite
signal from the dish as the vessel turns.
2. The antenna is at least 5 feet away from other transmitting antennas (HF, VHF
and radar) that may generate signals that may interfere with the Seaman anten-
na. The further away the Seaman antenna is from these other antennas, the less
impact their operation will have on it.
3. Direct radiation into the antenna from vessels radar, especially high power
surveillance radar arrays, is minimized. The radome should be as far away from
the vessels Radar as possible and should NOT be mounted on the same plane
as the vessels Radar.
4. The antenna radome assembly should be rigidly mounted to the vessel. If
necessary, reinforce the mounting area to assure that it does not ex due to the
vessel motion or vibration.
1. The antenna must have a clear view of the sky and the horizon at all the direc-
tions to avoid blockage of the satellite signal.
2. The antenna should be on the top of the vessel.
Good
Location
Best
Location
Poor
Location
Figure 2-2 Selecting the location
ENGLISH ENGLISH
12
13
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Megasat Seaman 45 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Megasat Seaman 45 in the language / languages: English as an attachment in your email.

The manual is 3,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Megasat Seaman 45

Megasat Seaman 45 User Manual - German - 23 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info