DEHUMIDIFICATION LIGHT
The LED light under the droplet and snowflake will stay on permanently, even once the
dehumidifier has reached its target humidity level. This light will be solid, it will not flash.
If the light is flashing, it is in defrost mode.
DEFROST MODE
This dehumidifier is equipped with an automatic defrosting system. When operating in
low temperatures, the surface of the evaporator will accumulate frost which effects the
efficiency of the dehumidifier. When this happens, the machine will automatically go into
periodic defrosting and the LED light beneath the droplet and snowflake symbol will
flash. The time the unit is in defrost mode will vary. This is not a fault; it is part of the
dehumidification process. It is not recommended to use the dehumidifier in
temperatures below 5°C.
WATER TANK FULL INDICATOR
When the water tank is full the dehumidifier will bleep multiple times and then switch off.
Once the water tank has been emptied and placed securely back in the dehumidifier,
the dehumidifier will start to run again as per its previous settings.
CHILD LOCK
Press both the UP and DOWN arrows at the same time for three seconds to activate
child lock, LC will appear on the display. This stops the functions of the dehumidifier
from being changed. The dehumidifier cannot be turned off when child lock is activated.
To deactivate child lock, press the UP and DOWN arrows at the same time again for
three seconds.
READINGS ON THE DISPLAY
When the dehumidifier is switched ON, the reading on the display will show
the current relative humidity level in the environment the dehumidifier
is being used in.
When the DOWN arrow is pressed once, the display will show the mode
the dehumidifier is set to, for example, it will either show the target
humidity level set, AP or CO. We recommend setting the dehumidifier to
reach a target humidity level of 50%rh or 55%rh. After two seconds the
display will then revert to the currently relative humidity level in the
environment. For more information of AP or CO mode, see page 13.
Once the target humidity level has been reached (is more than 3% below) the dehumidifier will go to
sleep for half an hour and the reading on the display may increase significantly, this is because the
dehumidifier is reading its internal humidity level, it is not showing the external relative humidity level in
the environment (see page 14 for more information).
