40
12-CLEANING
ATTENTION!
All the cleaning operations of all parts must be performed with the product completely cold and the plug
disconnected.
Disconnect the product from the 230V power supply before performing any maintenance operation.
The product requires little maintenance if used with certied good quality pellets.
DAILY OR WEEKLY CLEANING PERFORMED BY THE USER
Before each lighting
Clean the ash and any deposits in the brazier that could clog the air passage holes.
If the pellets in the hopper run out, unburned pellets may accumulate in the brazier. Always empty the residue in the brazier before each
ignition.
REMEMBER THAT ONLY A CORRECTLY POSITIONED AND CLEAN BRAZIER CAN GUARANTEE IGNITION AND OPTIMAL
OPERATION OF YOUR PELLET PRODUCT.
For the brazier to be cleaned properly, remove it from its housing completely and thoroughly clean all the holes and the grate on the
bottom. If good quality pellets are used, you will normally only need to use a brush to restore the optimal operating conditions of the
component.
After a long period of inactivity, (using a vacuum cleaner with a long pipe) remove any traces of pellets in the hopper that could have
absorbed moisture and are no longer suitable for combustion.
CLEANING THE GLASS
It is recommended to clean the ceramic glass with a dry brush, or if it is very dirty, spray a little specic detergent and clean with a cloth.
ATTENTION!
Do not use abrasive products and do not spray the glass cleaning product on the painted parts and on the door
gaskets (ceramic bre cord).
EXAMPLE OF A CLEAN BRAZIER EXAMPLE OF A DIRTY BRAZIER
