WARNING: Only charge the product
using a charging station which is
intended for it. Incorrect use may result
in electric shock, overheating or
leakage of corrosive liquid from the
battery.
In the event of leakage of electrolyte
flush with water and seek medical help
if it comes in contact with the eyes etc.
1. Press the ON/OFF button to start the
product.
2.
Place the product in the charging station.
Slide the product in as far as possible to
ensure proper contact between the product
and the charging station. Refer to contact
and charging strips in
Product overview on
page 4
3. The display shows a message that charging
is in progress.
4.9 Adjust the cutting height
The cutting height can be varied from MIN (2 cm /
0.8 in.) to MAX (5 cm / 2 in.).
CAUTION: During the first weeks after
a new installation, the cutting height
must be set to MAX to avoid damaging
the loop wire. After this, the cutting
height can be lowered step by step
every week until the desired cutting
height has been reached.
4.9.1 To adjust the cutting height
1.
Press the STOP button to stop the product.
2. Open the hatch.
3. Turn the knob to the required position.
• Turn clockwise to increase the cutting
height.
•
Turn counter-clockwise to decrease the
cutting height.
4. Close the hatch.
985 - 004 - 22.01.2019 Operation - 29
