684239
11
Zoom out
Zoom in
Previous page
1/27
Next page
English---11
115430026 Rev. 4 2/17/12
ASSEMBLY
Fitting a blade guard, grass
blade and grass cutter
S Hook the blade guard/combination guard
(A) onto the fitting on the shaft and secure
with the bo lt.
CAUTION! Use the recommended blade
guard. See the Technical data section.
S Turn the shaft until one of the holes in
the dust cup (B) aligns with the corre-
sponding hole in the gearbox.
S Insert a small screwdriver (C) in the hole
to lock the shaft.
S Place the blade (D) and retaining washer
(E) onto the shaft of the gearbox.
NOTE: Make sure the raised part of the
retaining washer is facing the gearbox
and the raised area fits into the hole in
the centre of the blade.
S Place the cupped washer (F) onto the
shaft with the cupped side of the washer
toward the blade.
S Install the blade nut (G). Tighten the nut
using the wrench (provided). Turn in the
opposite direction to the direction of rota-
tion (CAUTION! left-hand thread).
Fitting blades
IM PORTANT!
If a grass blade is to be used, the machine
must be equipped with the correct handle-
bar, blade guard and harness.
Correct balance
Let the cutting attachment rest lightly on
the ground. If you use a grass blade, it
should balance about 10 cm above the
ground to prevent contact with stones and
the like. Adjust the position of the harness
clamp to balance the unit correctly.
Correct height
Adjust the harness so that the cutting at-
tachment is parallel to the ground.
A
C
D
E
F
G
B
W ARNING: Never use a cutting
attachment without an approved
guard. See the section on Techni-
cal data. If an incorrect or faulty
guard is fitted this can cause seri-
ous personal injury.
W ARNING: When fitting blades,
it is extremely important that the
raised section on the retaining wash-
er engages correctly in the centre
hole of the blade. If the blade is fitted
incorrectly , it can result in serious
and/or fatal personal injury .
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for McCulloch B28 B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of McCulloch B28 B in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 0,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info