INP UT
6V
0.2 V
40H z 180H z
R
L
INPUT LEVE L
LOW PASS
0dB 12d B
BASS BOOST
15H z 55 Hz
SUBS ONIC
REM OTE
SLA VE
IN
MAS TER
OUT
SLA VE
IN
MAS TER
OUT
FUS E
POW ER IN PUT
GND REM 12V
SPE AKER OU TPUT
INTERCONNECTION
• Connect the RCA lineouts of the headunit with the RCA jacks LINE INPUT of the amplifier with appropriate high-value RCA cables.
If your headunit is equipped with a additional subwoofer lineout (SUB OUT), it is recommended to use this lineout.
• Connect the subwoofer with the speaker outputs (SPEAKER OUTPUT + / -) by using appropriate wires.
• Ensure by any means, that the total impedance load of subwoofer is not lower than 1 ohm. Too low impedance cause high
temperature and will shut down the amplifier operation.
• Always ensure the correct polarity of the speakers. The interchange of plus and minus cause total loss of bass playback and could
damage the speakers.
SLAVE IN/MASTER OUT SWITCH
• The SLAVE IN/MASTER OUT switch must be in position MASTER OUT.
LEVEL CONTROLLER
• Turn the INPUT LEVEL controller of the amplifier to the 6V position.
• Turn the volume controller of the headunit to 80 - 90% of its full setting.
• Turn the INPUT LEVEL controller clockwise until you hear some distortion.
• Then turn back the INPUT LEVEL controller slightly until you hear a cleaner sound.
BASS BOOST CONTROLLER
• The BASS BOOST controller adjusts the bass enhancement between 0db and +12dB.
• A too high bass boost may cause clipping/distortion and damage on the loudspeakers and also may harm your hearing abilities.
Use this controller carefully!
LOW PASS CONTROLLER
• The LOW PASS controller adjusts the cut-off point of the frequency range to above. The cut-off frequency is continuously
adjustable from 40 Hz to 180 Hz.
SUB SONIC CONTROLLER
• The SUB SONIC controller (Subsonicfilter) limits the ultralow and not hearable frequencies of the audiosignal to below, to avoid a
mechanical and electrical overloading on the subwoofer. The cut-off frequency is adjustable from 15 to 55 Hz and depends on the size
of the subwoofer.
BASS REMOTE
• The enclosed BASS REMOTE Controller adjusts the bass-level e.g. from the driver’s seat.
Please use only the enclosed bass remote controller and cable.
INTERCONNECTION EXAMPLE Low Pass-Mode (Standard Subwoofer Operation)
Connect the bass remote
controller and the
remote terminal on the amplifier
with the enclosed cable.
Connect stereo RCA output
(R/L or SUB OUT)
of the headunit with
LINE INPUT R/L of the amplifier
Subwoofer
1 – 8 Ohms
Switch position MASTER OUT
L R
I N T E R C O N N E C T I O N E X A M P L E S
NSC750
18
MAXMIN
PROTECTPOWER
