169964

Maxdata platinum 2200 ir Manual

25
Zoom out
Zoom in
Previous page
1/44
Next page
25MAXDATA Server PLATINUM 2200 IR M6
Removing and Installing the PCI Riser Assembly
Always operate your server chassis with the PCI riser assembly in place. The riser assembly is required
for proper airflow within the chassis. You will need to remove the PCI riser assembly from the chassis
to replace the PCI riser connectors, or to add or remove a PCI add-in card.
Removing the PCI Riser Assembly
Use the following instructions to remove the PCI riser assembly from the chassis.
1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover.
4. Remove the processor air duct.
5. Disconnect any cables attached to any installed add-in cards.
6. Lift up on the two levers on the PCI riser assembly to lift the riser assembly from the chassis.
See the figure below.
Figure 20. Removing the PCI Riser Assembly from the Chassis
Installing the PCI Riser Assembly
1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover.
4. Remove the processor air duct.
5. Install any necessary add-in cards into the PCI riser assembly.
6. Install any cables onto add in cards that require them. See your add-in card documentation for
information and add-in card requirements.
7. Set the riser assembly straight down, matching the hooks in the back of the riser assembly to
the notches in the rear of the chassis.
8. Press firmly to push the riser into the slots on the server board.
9. Install the processor air duct.
10. Install the chassis cover.
A
B
… 25 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Maxdata platinum 2200 ir at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Maxdata platinum 2200 ir in the language / languages: English as an attachment in your email.

The manual is 2,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info