Manual Maxdata platinum 2200 ir (page 24 of 44) (English)

169964

Zoom out

Zoom in

1/44

24 Hardware Installations and Upgrades

Figure 19. Attaching a Hot-swap Hard Disk Drive to a Drive Carrier

9. With the black lever in the fully open position, slide the drive assembly into the chassis. The

green latch at the front of the drive carrier must be to the right. See letter “A” in the figure

below. Do not push on the black drive carrier lever until the lever begins to close by itself.

10. When the black drive carrier lever begins to close by itself, push on it to lock the drive

assembly into place.

Removing a Hot-swap Hard Disk Drive

1. Remove the front bezel if it is installed.

2. Press in on the green latch at the front of the hard drive carrier.

3. Pull out on the black lever to slide the carrier from the chassis.

4. Remove the four screws that attach the hard drive to the drive carrier. Lift the drive from the

carrier. Store the drive in an anti-static bag.

5. If you are not installing a new drive, place the plastic retention device into the drive carrier,

using the four screws you removed from the hard drive.

6. With the black lever in the fully open position, slide the drive carrier into the chassis. The green

latch must be to the right. Do not push on the black lever until the lever begins to close by

itself.

 NOTE

For proper airflow, the hard drive carrier must be replaced in the chassis, even if no hard drive is

installed in it.

7. When the black lever begins to close by itself, push on it to lock the drive carrier into place.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Maxdata platinum 2200 ir in the language / languages: English as an attachment in your email.

The manual is 2,22 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Maxdata platinum 2200 ir Manual

Product: