797862

Masterpro BGMP-9169 Manual

10
Zoom out
Zoom in
Previous page
1/18
Next page
Read the following instructions carefully and be sure your gas pizza oven is properly
installed, assembled and cared for. Failure to follow these instructions may result in
serious bodily injury and/or property damage.
If you have any questions concerning assembly or operation, consult your dealer or
LPG Gas Company.
When used on the ground always place the appliance and cylinder on flat level
ground.
Your gas pizza oven can be used with gas cylinders between 11 kg and 15 kg. The
maximum size of the gas cylinder should be: Dia. 320mm, Height: 600 mm. Follow
the technical information as stated in the instruction manual and Check with your
local gas supplier to have a suitable gas cylinder for your pizza.
NOTE FOR CONSUMER: Retain for future Reference
CONNECTING THE GAS CYLINDER TO THE APPLIANCE
This appliance is only suitable for use with low-pressure butane or propane gas or LPG
mixtures, fitted with the appropriate low-pressure regulator via a flexible hose.
The hose should be secured to the regulator and the appliance with hose clips. Make
sure the flexible hose could not come in contact with hot surface and avoid twisting.
Use a suitable regulator that is certified to BSEN 12864 or EN 16129. Make sure the
regulator and flexible hose comply with local code.
Please consult your LPG dealer for information regarding a suitable regulator for the
gas cylinder.
Regulator and Hose
Use only regulators and hose approved for LP Gas at the above pressures. The life
expectancy of the regulator is estimated as 2 years.
The use of the wrong regulator or hose is unsafe; always check that you have the
correct items before operating the appliance.
The hose used must conform to the relevant standard for the country of use. Worn or
damaged hose must be replaced. Ensure that the hose is not obstructed, kinked, or in
contact with any part of the appliance other than at its connection.
For Flexible hose
Avoid twisting the flexible tube when the appliance is in use. The length of flexible
hose shall not exceed 1.5m. In Finland, the length shall not exceed 1.2m. The hose
should certified according to applicable EN Standard and comply with local code.
Storage of Appliance
Storage of an appliance indoors is only permissible if the cylinder is disconnected and
removed from the appliance. When the appliance is not to be used for a period of time
it should be stored in its original packaging and stored in a dry dust free environment.
Gas Cylinder
The gas cylinder should not be dropped or handled roughly! If the appliance is not in
use, the cylinder must be disconnected. Replace the protective cap on the cylinder
after disconnecting the cylinder from the appliance. The gas cylinder must be sited
outside the body of the appliance.
Always connect or replace the cylinder in a well-ventilated area and away from any
source of ignition, never in the presence of a flame, spark or heat source. Cylinders
must be stored outdoors in an upright position and out of the reach of children. The
cylinder must never be stored where temperatures can reach over 50°C. Do not store
the cylinder near flames, pilot lights or other sources of ignition. DO NOT SMOKE.
This gas pizza oven is designed for use outdoors, away from any flammable materials.
It is important that there are no overhead obstructions and that there is a minimum
distance of 1 m from the side or rear of the appliance. It is important that the ventila-
tion openings of the appliance are not obstructed. The appliance must be used on a
levels, stable surface. The appliance should be protected from direct draughts and
shall be positioned or protected against direct penetration by any trickling water (e.g.
rain).
Make sure that the gas cylinder compartment (if any) is not obstructed, keep it
ventilated and clean.
Parts sealed by the manufacturer or his agent must not be altered by the user. No
modifications should be made to any part of this pizza oven and repairs and mainte-
nance should only be carried out by a registered service engineer.
Connection to Appliance
Before connection, ensure that there is no debris caught in the head of the gas
cylinder, regulator, burner and burner ports. Spiders and insects can nest within and
clog the burner/venturi tube at the orifice. A clogged burner can lead to a fire beneath
the appliance.
Fit the hose to the appliance using a spanner to tighten it onto the connection thread.
If the hose is replaced it must be secured to the appliance and regulator connections
with hose clips. Disconnect the regulator from the cylinder (according to the direc-
tions supplied with the regulator) when the appliance is not in use.
The appliance must be used in a well ventilated area. Do not obstruct the flow of
combustion air to the burner when the appliance is in use.
ONLY USE THIS GAS PIZZA OVEN OUTDOORS.
ENEN
Make 2-3 fluid ounces of leak detecting solution by mixing one part washing up liquid
with 3 parts water.
Ensure the control valve is "OFF".
Connect the regulator to the cylinder and ON/OFF valve to the burner, ensure the
connections are secure then turn ON the gas.
Brush the soapy solution onto the hose and all joints. If bubbles appear you have a
leak, which must be rectified before use.
Retest after fixing the fault.
Turn OFF the gas at the cylinder after testing.
If leakage is detected and cannot be rectified. Do not attempt to cure leakage but
consult your gas dealer.
TO CHECK FOR LEAKS
1. Ensure well ventilation before lighting the burner.
2. Make sure the knob is in the "OFF" position. Then push the control knob and slowly
turn the knob anticlockwise to "HI” position for 5 seconds until you hear a click and
the burner ignites (A). If not repeat this process.
3. You can adjust the fire from HI to LOW by slowly turn the control knob clockwise (B)
4. Please turn the control knob to "HI” position, then push the knob and clockwise to
"OFF” position to turn off your pizza oven. (C)
5. If the burner has not lit after retrying wait 5 minutes and repeat step 2.
LIGHTING INSTRUCTIONS
BEFORE USE CHECK FOR LEAKS
Never check for leaks with a naked flame, always use a soapy
water solution
17 18
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Masterpro BGMP-9169 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Masterpro BGMP-9169 in the language / languages: English, German, Spanish as an attachment in your email.

The manual is 8.88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info