487654
8
Zoom out
Zoom in
Previous page
1/85
Next page
INSTALLATION
5. Mount the sleeve by inserting the sleeve into th
e
opening of the dashboard and bend open the
tabs located around the sleeve with a
screwdriver. Not all tabs will be able to make
contact, so examine which ones will be most
effective. Bending open the appropriate tabs
behind the dashboard to secure the sleeve in
place.
(1) Dashboard (2) Taps
6. Reconnect the wire harness and the antenna
and be careful not to pinch any wires or cables.
7. Slide the unit into the sleeve until it locks in
to
place.
8. To further secure the unit, use the supplied
metal strap to secure the back of the unit in
place. Use the supplied hardware (Hex Nut
(M5mm) and Spring Washer) to attach one end
of the strap to the mounting bolt on the back of
the unit. If necessary, bend the metal strap to fit
your vehicle’s mounting area. Then use the
supplied hardware (Tapping Screw and Plain
Washer) to attach the other end of metal strap to
a solid metal part of the vehicle under the
dashboard. This strap also helps ensure proper
electrical grounding of the unit.
Note to install the short threading terminal of the
mounting bolt to the back of the unit and the other
long threading terminal to the dashboard.
(1) Metal Strap; (2) Mounting Bolt; (3) Hex Nut;
(4) Spring Washer; (5) Tapping Screw;
(6) Plain Washer
9. Reconnect the cable to the vehicle battery’s
negative (-) terminal. Then replace the out trim
ring.
Removing the unit
1. Make sure the ignition is turned off, then
disconnect the cable from the vehicle battery’s
negative (-) terminal.
2. Remove the metal strap attached the back of the
unit (if attached).
3. Lift the top of the outer trim ring then pull it
out to
remove it.
4. Remove the four screws on the left and the right
side of the unit then pull the unit out of the
dashboard.
8
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Marquant MCR-1307 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Marquant MCR-1307 in the language / languages: English, Dutch, French as an attachment in your email.

The manual is 3,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info