487654

Marquant MCR-1307 Manual

7
Zoom out
Zoom in
Previous page
1/85
Next page
INSTALLATION
Notes:
Choose the mounting location where the unit
will not interfere with the normal driving function
of the driver.
Before finally installing the unit, connect the
wiring temporarily and make sure it is all
connected up properly and the unit and the
system work properly.
Use only the parts included with the unit to
ensure proper installation. The use of
unauthorized parts can cause malfunctions.
Consult with your nearest dealer if installation
requires the drilling of holes or other
modifications of the vehicle.
Install the unit where it does not get in the
driver’s way and cannot injure the passenger if
there is an emergency stop.
If installation angel exceeds 30°from horizontal,
the unit might not give its optimum
performance.
Avoid installing the unit where it would be
subject to high temperature, such as from direct
sunlight, or from hot air, from the heater, or
where it would be subject to dust, dirt or
excessive vibration.
DIN FRONT/REAR-MOUNT
This unit can be properly installed either from
“Front”(conventional DIN Front-mount) or
“Rear”(DIN Rear-mount installation, utilizing
threaded screw holes at the sides of the unit
chassis). For details, refer to the following illus
trated
installation methods.
TAKE OUT SCREW BEFORE INSTALLATION
Before install the unit, please remove the two
screws.
DIN FRONT-MOUNT (Method A)
Installation Opening
This unit can be installed in any dashboard having
an opening as shown below:
Installing the unit
Be sure you test all connections first, and then
follow these steps to install the unit.
1. Make sure the ignition is turned off, and then
disconnect the cable from the vehicle battery’s
negative (-) terminal.
2. Disconnect the wire harness and the antenna.
3. Lift the top of the outer trim ring then pull it
out to
remove it.
4. Use the screwdriver to remove the four screws
on the left and the right side of the unit then you
can remove the sleeve.
30
Take out screw
before installation.
Sleeve
Screws
Outer Trim Ring
Unit
Screwdriver
7
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Marquant MCR-1307 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Marquant MCR-1307 in the language / languages: English, Dutch, French as an attachment in your email.

The manual is 3,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info