494248
6
Zoom out
Zoom in
Previous page
1/52
Next page
6 © MARMITEK
Position the IR LED within range of the remote control, e.g. on the top of the TV.
Plug the power adapter into the wall socket.
Tip 1
There are two types of antenna plugs in Europe: the IEC plug and the F plug. This last
one causes the least loss of signal and is used in superior installations. Your Marmitek
VideoControl3 also uses an F plug. With the adapters included you can also connect
IEC plugs.
Installation of the transmitter
Connect the ‘IN’ side of the VideoControl3 transmitter (with the character
T on the
device and with the IR LEDs) to the COAX cable near the satellite receiver or video
recorder in the room the equipment you want to control is situated.
Connect the ‘TO TV’ plug to the antenna IN of the TV or satellite receiver.
Use the coax extension plug included if necessary.
Stick the LEDs on the IR windows of the equipment. This should be done very
carefully and precisely. Test whether the LEDs are in the right
place first (with another person holding them) before you stick them down.
Plug the power adapter into the wall socket.
ATTENTION: if you connect less than 3 devices, do not remove the other LEDs from
the cable.
VideoControl3_manual_20125_20060704.qxd 11-12-2006 15:32 Pagina 6
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Marmitek VideoControl 3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Marmitek VideoControl 3 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info